Examples of using Be set automatically in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Other parameters can be set automatically.
The Clock can be set automatically if you are receiving a digital signal.
At the same time, however,everything can be set automatically.
The time can be set automatically via the RDS signal.
Burn speed and other options can all be set automatically.
People also translate
Responses can be set automatically for XML and JSON based on the accept header.
The test times can be set automatically;
Address can be set automatically and manually, long distance of signal transmitting.
Recording speed andother options can be set automatically.
If for some reason the clock cannot be set automatically, use the following procedure to set it manually.
For each demand there is a responsible person,which can be set automatically.
For shooting, will also be set automatically for the slave units.
Within these restricted areas other cookies may be set automatically.
The time can be set automatically by SNTP by pressing the“SELECT” button to make“auto set by SNTP” flash, then pressing the“PLAY/PAUSE” button.
IndexMetatags of the nova search should be set automatically. 4975367.
The calibration level can be set automatically by the Konftel 300 or adjusted manually to any value between 0 and 5 0 being full duplex.
The desired adhesive application width can be set automatically or manually.
By pressing the both deck A and B Rec Pause( 3) button!4,the recording pause or recording mute mode on both decks can be set automatically.
Compression settings and thresholds will also be set automatically using the Track Assistant function.
The ZE-Series electronic interface ensures that the exposure can be set automatically and that EXIF data, such as lens manufacturer and focal length, is passed on to the body, allowing you to work faster.
Users are informed that during their visits to the site www. be-only. com,a cookie may be set automatically and stored temporarily in memory or on the hard drive.
When compared to a classic fieldbus system, EtherCAT is the obvious choice:node addresses can be set automatically, there's no need for network tuning, and onboard diagnostics with fault localization make pinpointing errors a snap.
It is set automatically upon closure of the'Cookie settings' information layer.
The time and date are set automatically based on the GPS position.
Some of these options are set automatically, while others can be set manually.
The synthetic records that are set automatically are: .
This field is set automatically and cannot be edited.
Late- the status is set automatically after the check-out date.
The cutting modes are set automatically from the tool library.
The optimum water temperature is set automatically for each cycle.
