Examples of using Compression cycle in English and their translations into Spanish
{-}
-
Official
-
Colloquial
Other sequential compression cycles are also contemplated.
NOTE: A noise will be heard when finding the start of the compression cycle.
One complete compression cycle takes approximately 40 seconds.
Provides consistent, repeatable performance over thousands of compression cycles.
Keywords: vapor compression cycle, heat exchangers, thermophysical properties.
The absence of dead volume at the end of the compression cycle ensures better performance.
The difference between the numerically integrated loading andunloading curves gave the energy lost in each compression cycle.
To know the ideal steam compression cycle for refrigeration and heat pumpling applications.
It works in a similar way to any domestic refrigerator, using a vapour compression cycle.
The compression cycle would only contribute 5% of the heat added to the tube, with 95% of the heat attributed to radiation and convection into the tube.
Some work is required by the liquid pump but, for a given quantity of refrigerant,it is much smaller than needed by the compressor in the vapor compression cycle.
For given extreme temperatures,a gas cycle may be less efficient than a vapor compression cycle because the gas cycle works on the reverse Brayton cycle instead of the reverse Rankine cycle. .
Thermoelectric junctions are typically around 10% as efficient as the ideal Carnot cycle refrigerator,compared with 40% achieved by conventional compression cycle systems.
Considering current technology,the Panel suggested that the vapour compression cycle would be hegemonic for decades to come, with the main options being the replacement of HCFCs with alternative refrigerants.
In response to another question,another member of the Panel said that HFC-152a was suitable for use in a vapour compression cycle, provided that flammability issues were addressed.
This indicates that the piston is moving upward on the compression cycle, and the intake and exhaust valves are closed. The piston pushes a small amount of air from the spark plug hole on compression. .
As there is no condensation and evaporation intended in a gas cycle, components corresponding to the condenser and evaporator in a vapor compression cycle are the hot and cold gas-to-gas heat exchangers.
This is achieved with an intermediate vapor injection during the compression cycle thus reducing the high working frequency of the compressors, allowing an increase of the heat production capacity with lower energy consumption.
Within heat pumps, we can distinguish between the following categories: electrically driven, such as the most widespread model, where the energy required to move the compressor is obtained by means of an electric motor; gas powered, where the compressor is driven by an internal combustion endothermic engine; and thermally driven,where the state of the refrigerant is changed by means of a thermal absorption or compression cycle.
A member of the Panel said that, as had been mentioned in the presentation,the dominant technology for the near future was the vapour compression cycle, although the absorption cycle had certain advantages, depending on the energy matrix of the country using it.
He said that, given that current refrigeration and air conditioning technologies,which used the vapour compression cycle, would be dominant over the coming decades, the main options regarding the replacement of HCFCs were represented by alternative chemical refrigerants, both synthetic and non-synthetic.
In the early years of the twentieth century, the vapor absorption cycle using water-ammonia systems was popular and widely used but,after the development of the vapor compression cycle, it lost much of its importance because of its low coefficient of performance about one fifth of that of the vapor compression cycle.
High fatigue performance under bending and/or tension/compression cycling loads given by maximized radii and avoidance of stress-risers.
To describe the scheme of a simple/multiple vapor compression refrigeration cycle.