Examples of using Compression driver in English and their translations into Spanish
{-}
-
Colloquial
-
Official
HF compression driver w/L-Pad level control.
Woofer and 1.5" high-frequency titanium compression driver.
A compression driver with a 44mm titanium diaphragm is used for the high frequency way.
Both loudspeakers are equipped with a 1.4" exit compression driver.
The high frequency way uses high efficiency compression driver with 1''nylon membrane coupled to a constant directivity horn.
High-output IF driver/ 1.4″ titanium dome compression driver.
For high frequencies a high efficiency 1" compression driver with a nylon diaphragm has been used in conjunction with an adjustable CD-horn having 90x60 º dispersion.
It applies to home theatre system, professional audio and compression driver.
ILLUNIS 8A: it is fitted with a 1” compression driver horn and with a 8” woofer.
Some preference is given to results that also have the phrase compression driver.
The high frequency section combines a 1”(25mm) mylar diaphragm compression driver with an elliptical horn for very high output capability and wide, even high frequency coverage.
The host drive was usually mapped to the letter H: by the compression driver.
These boxes typically included multiple vertically aligned high frequency compression drivers andmultiple midrange and low drivers arranged symmetrically around the compression driver.
The HF OUT terminals are factory-connected to the compression driver.
However, if the compression driver had failed to load the user might see it as drive C: Turning off the computer before DoubleSpace could finish updating its data structures could also result in data loss.
Transducers: 15" cone transducer, 1.75" diaphragm compression driver.
Six terminals: Two full-range input terminals, two HF OUT terminals(factory wired to compression driver), and two LF OUT terminals with factory supplied wiring for connection to QSC LF-3115 or LF-3215 low frequency loudspeaker.
Search results have the phrase limiting butNOT the phrase"compression driver" in them.
The HF-63X1/X2 high-frequency system features a large format, 2.5”(63.5mm) titanium diaphragm compression driver mounted on a custom designed high-frequency cinema horn with an adjustable pan and tilt bracket.
HF: 1.5"(38mm) exit, 3"(76mm) voice coil, titanium diaphragm compression driver.
Satellites are loaded with a 12" HK Audio Custom speaker and a 1.4" compression driver with a 60 x 40 BEM CD horn.
It combines an enclosed 10” speaker attached to a Tractix horn with phase correction and a 2” compression driver.
In particular, the two 10" high quality woofers with neodymium magnets and a 3" titanium compression driver(1/4" output) are optimized thanks to.
INGENIA IG1T integrates, in a reinforced polypropylene cabinet weighing 10.8 kg(23.81 lbs.),two 6.5” woofers and a one 1.4” compression driver exit voice coil.
Ensure only high frequency signal is applied to HF INPUT terminals or compression driver damage will occur.
High-output IF driver/ 1.4" titanium dome compression driver.
INGENIA IG1T isa vertical 2-way speaker, equipped with two 6.5” woofers and one 1” compression driver exit voice coil.
The 2-way passive design features two 8" drivers in a dipole arrangement and a centrally mounted 1.4" compression driver with a wave transformer.
Depending on what speaker cabinet your signal is headed for,use this switch to select Horn(for a cabinet with a tweeter or compression driver) or No Horn for a cabinet without a tweeter or compression driver.
The PR 15D features a bi-amped power section that provides 150 watts powerfor the woofer and 50 watts power for the compression driver tweeter, both with DDT compression. .