Examples of using Corresponding LED in English and their translations into Spanish
{-}
-
Colloquial
-
Official
Once activated, the corresponding LED will be on.
The corresponding LED for the cycle in progress is illuminated.
The unit of reading is the unit indicated by the corresponding LED.
The corresponding LED for the defective drive will be blinking slowly.
When a function is selected, the corresponding LED is illuminated.
The corresponding LED for the defective drive will be blinking slowly.
When the batteries are full, the corresponding LED will flash.
A corresponding LED in the rear of the NAS will blink to identify.
The selection is displayed when the corresponding LED comes on.
Once selected, the corresponding LED indicator on the top panel will light up.
When the effect processor is turned on, the corresponding LED illuminates.
A corresponding LED light will illuminate to indicate all selections. See Figure 1.
After executing this operation the corresponding LED display will light up.
The corresponding LED lights on the remote to indicate which massage mode is currently in use.
The function is enabled when the corresponding LED is illuminated.
A corresponding LED on the rear of the NAS will also blink amber to identify the unit in the rack.
To deselect, press the button again and the corresponding LED light will turn off.
The further outside the corresponding LED lighting up is located in the LED row, the less the two music titles are synchronized.
The operating mode will be indicated by the corresponding LED, lighting up in green.
The green LED in the charger with the sensor connected to it, will be lit continuously,the other chargers will blink the corresponding LED.
The deadband and corresponding LED change with each press.
As connections are established with the24-Port10/100Mbps Switch, the corresponding LED lights will turn on.
If any of these conditions exist, the corresponding LED warning will blink and the charger will not begin the charging process.
If an option is not compatible with the selected was cycle(see Table of wash cycles), the corresponding LED flashes rapidly 3 times.
When one of the two functions is active, the corresponding LED, under the display, will light up.
If the seasonal manual changeover button is pushed while the centralised changeover mode is activated, the corresponding LED will briefly flash while maintaining the activated mode.
Simply press the‘Speed' button and the corresponding LED illuminates to indicate your selection.
If an option is not compatible with the selected wash cycle(see Table of wash cycles), the corresponding LED flashes rapidly 3 times and 2 short beeps will sound.
When the tap delay effect is selected, the corresponding LED will flash at the intervals selected.
When activated, the blower will turn on low and the corresponding LED will blink, indicating an overtemperature condition.