Examples of using Correct length in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Correct length of body.
The hip should be of the correct length.
If the arms are the correct length, it makes the suit feel better fitted.
These sleeves seem to be the correct length.
Its important to choose the correct length in order to preserve the effect and duration of the straps.
Feminin well shaped head. Correct length.
Select the correct length of the droping list, we send a shipping label via
Align the borders with the tape to get the correct length.
Insert the elastic, adjust to the correct length and sew the elastic ends together.
For optimal ergonomic work, the stem must have the correct length.
Note that not all players are able to show the correct length of MP3 files that were recorded with variable bit rate.
adjust the shoulder straps/snaps to the correct lengths.
Most modern hangeroc reproduction already are the correct length, so turtle brooches are often not needed for practical purposes.
Standard lie angle works for the vast majority of players if they have the correct length.
The height-adjustable stanchion is set to the correct length and placed in the gutter.
easily cut to the correct length.
It is important when Buy railing rack however, that the correct length is chosen
In this way, a telescopic ladder is many ladders in one- always the correct length for the job.
You will use a utility knife to cut a piece of flashing of the correct length and you will form it into a cylinder shape to secure the edge with duct tape.
locks the cord at the correct length with the cam cleat.
Cut the pipe to be connected to the unit by sawing it to the correct length so that the ventilation pipe succeeding the flexible pipe goes upright along the wall.
it moves on to the robot cutter, where the timber is cut to the correct length.
for curtains and have the correct length, add only Acc allowances on top
that L1's former must be cut to the correct length.
cut the new bracket pin to the correct length(see steps 2
X 10mm wide self adhesive copper foil tape(or shim stock which will need to be bent in to shape to match the curves on the shield) You can use a strip of paper to work out the correct length for your print.
then carefully stretched to the correct length, and to identify the two end coil shown in Figure 2.
Below are instructions on how to easily measure the correct length of your feet.