Examples of using Current to flow in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Never allow the current to flow from nipple to nipple.
which allows current to flow in only one direction.
This causes the current to flow along its length rather than from side to side.
A diode is a component that allows the electrical current to flow in one single direction.
This allows current to flow into the cock loop from both ends reducing resistance
It is turned on via the 47k resistor and this causes current to flow in the collector-emitter circuit.
it gives a very good amount of surface area at the tip of your penis and inside you along its length for the current to flow.
As it cures the graphite particles touch and allows a current to flow through the previously insulating silicone.
the voltage across the capacitor causes current to flow back to the coil to produce flux.
This top insulation of the lower cock ring will cause the current to flow down and through the perineal nerves to the lower side of the cock ring at the base of your scrotum.
Physical dimension. Causes charge carriers to be set in motion and electrical current to flow in an electrical conductor.
there is high frequency electric current to flow to pass and produce parasitism radiation outside the screen layer of cable,
one without the quantum phase coherence required for current to flow with no resistance," said physicist Seamus Davis of the U.S.
prevent high frequency electric current to flow to cable screen layer cortical,
holes that exist in the material cause the current to flow around them, thereby creating holes in the shield itself to the frequencies that are needing to be reflected.
meaning it permits the electrical current to flow through it, while an insulator is the opposite:
This will cause minute currents to flow where they shouldn't, triggering system check failures
Through the plasma from one electrode to another current begins to flow.
Reconnect frame to current flow.
Spot Welding is a process in which contacting metal surfaces are joined by the heat obtained from resistance to electric current flow.
As we remember, the current tends to flow in the direction of least resistance.
In an SF6 circuit-breaker, the current continues to flow after contact separation through the arc whose plasma consists of ionized SF6 gas.
this metal vapor provides a path through which electric current continuous to flow until the next current zero.