Examples of using Short-circuit current in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
Short-circuit current up to 25 kA.
Contact burns when breaking a large short-circuit current.
To prevent large short-circuit current burn failure point.
This is sufficient to protect against overloads and short-circuit current at.
The short-circuit current of test power>
the circuit breaker's breaking short-circuit current with full capacity up to 30 times.
have been described to facilitate with the computation of the short-circuit current.
Compared with the two, the short-circuit current is several hundred times different from the breakdown current. .
over-loading current and short-circuit current.
High voltage digital insulation resistance tester output short-circuit current can be measured directly, without load measurement to estimate.
The dead zone or the malfunction of the protection system causes the transformer winding to withstand the short-circuit current for too long.
The mathematical part of this thesis work teaches how to calculate the short-circuit current in a transmission line in two different ways using two different methods.
high-voltage constant current source, no-load voltage is -15000V, short-circuit current is 30mA.
However, it cannot disconnect the short-circuit current, so it is generally used in series with a high-voltage fuse,
Installing fast-acting current limiting devices can reduce the short-circuit current to acceptable values.
To protect the system from short-circuit current an experiment was conducted to detect the short circuit current
there is no big short-circuit current to burn the fault point.
The main objective is to be able to determine the maximum short-circuit current of any transmission line and to be able to transfer power in a safe manner by using the SPAA 120 C feeder protection relay.
The reason for this may be that the test piece is short-circuited under high voltage and the short-circuit current is large, so all the lights are on.
When the transformer is subjected to the impact of short-circuit current or in the course of transportation, it is possible to have the phenomenon of winding deformation, which will directly affect the safe operation of the transformer.
power systems with higher short-circuit current as purpose of power controlling/ reception/ distribution.
If there is something wrong on any part of the power system, the switchgear must operate quickly so that no damage is done to generators, transformers and other equipment by the short-circuit current.
cannot cut off the load current and the short-circuit current, so the circuit must be disconnected in the circuit breaker.
to decrease starting current rushes and short-circuit current.
Important: When installing zeroing must be borne in mind that the short-circuit current must reach the melting insert values fuse
first the short-circuit power at that point is calculated and then the short-circuit current is calculated by using a simple formula.
serious overload current, short-circuit current exceeds the instantaneous trip setting current value,
has the ability to make short-circuit current, and bear short-circuit current in certain times.
avoiding short-circuit current of the motor increase,
especially when the short circuit point is very close to the secondary exit of the transformer, the short-circuit current will be very large,