Examples of using Test surface in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
The test surface shall meet four design requirements.
The sound has evenly distributed angles of incidence against the test surface.
The test surface shall meet four design requirements.
The following data shall be given in a document describing the test surface.
Documentation of the test surface and of tests performed on it.
lawn edge trimmers should be positioned as close as possible to the test surface.
Measurements of air as well as test surface temperature are mandatory.
The test surface shall not be artificially cooled during
Date and method of check on compliance of the test surface with ISO 10844:1994.
On the test surface, a step-noise machine is placed which is a machine of several weights in a row that is lifted
Meteorological conditions inclusive of air and test surface temperature for each test run.
On the test surface, a step-noise machine is placed which is a machine of several weights in a row that is lifted
After each washing cycle exactly 3 ml of water was dropped on the test surface with a laboratory pipette.
A section in a high-traffic area was chosen as a test surface to enable the customer to monitor the floor over a period of time. This resulted in a carefully
it is expected that the tyre-road noise level measured on the test surface may increase slightly during the first 6- 12 months after construction.
The sensor should be positioned at a height of 1,2 m± 0,1 m above the test surface level in order to minimise the influence of the test surface thermal radiation at low airflows.
structure of boundary films formed on the test surfaces to get the most accurate information about their nature.
In order to guarantee the best possible outcome, preparations included three test surfaces, which were analysed carefully with regard to everything from cavities to structure.
The values denote the size of the wear scar generated on the tested surface.
The tested surfaces ranged from Ra 0.15 to 2.4 Î1⁄4m.
Industrial applications include testing surface quality and cleanliness,
Stability on a horizontal supporting surface test for section 3.1.1.4.
Disk surface test to check and find bad sectors
Test the surface to view and edit the sector, compress MFT(master file table)
