Examples of using This detector in English and their translations into Swedish
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
-
Political
You will be very pleased with this detector!
The mere sight of this detector may be"bad guys" to turn in the door.
Please contact us if you are interested in this detector.
But actually, this detector works in a bit of a strange way.
iron below us… to reach this detector.
We expect that this detector will be a real workhorse in the future.".
By requesting this detector you're agreeing to the programme Terms and Conditions.
Compared to standard motion detectors from the JABLOTRON 100+ series, this detector is designed for ceiling installation.
The principle of this detector is simple,
that half-mile of rock above us, of rock and iron below us to reach this detector.
This detector has solid angles significantly greater than any commercially available SDD for TEM.
Thanks to the CdTe based sensor, this detector has 100% efficiency even for hard radiation e.g.
This detector generates a voltage in a junction of two metals on application of heat.
The most sensitive is the tip which makes this detector easily can pin-point a bugg
This detector is designed by utilizing the modernize technology
the large magellanic cloud of rock and iron below us to reach this detector.
This detector has two buttons,
iron below us to reach this detector. they had to pass through the thousands of miles Now remember, the large magellanic cloud so the neutrinos didn't come through.
This detector has two buttons,
Infrared detection This detector is very selective measuring a selected gas at a specific absorbtionsband in the infrared wavelength area- no false alarms.
This detector is factory-set to alert a low-alarm condition when the level of O2 less than 18%vol,
If I showed you this detector, you would be likely to think to begin with that the way to make the detector go would be to put a block on top of the detector. .
This detector works as an excellent complement to either a larger deep search metal detector or to be able to search a very small area.
This detector is factory-set to alert a low-alarm condition when the level of O2 less than 18%vol,
This detector is very selective measuring a selected gas at a specific absorbtionsband in the infrared wavelength area- no false alarms.
This detector is factory-set to alert a low-alarm condition when the level of H2S reaches 10 parts per million(ppm),
This detector is factory-set to alert a low-alarm condition when the level of CO reaches 50 parts per million(ppm),
This detector is factory-set to alert a low-alarm condition when the level of H2S reaches 10 parts per million(ppm),
This detector is with a back-mounted alligator clip to allow the unit to be worn on a belt,