Examples of using Anode in English and their translations into Vietnamese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Chemical compositions of cast magnesium anode(%).
The anode and backfill are contained in a permeable cotton cloth bag.
Negatively charged ions(anions) move towards the electron-extracting(positive) anode.
When applied by electrophoresis, the drug is administered from the anode to the affected area for 20-30 minutes.
The maximum loop length can be calculated from theconfluence point to obtain the maximum length of the anode.
People also translate
There are many laying patterns when linear anode is applied to cathodic protection of outer surface of tank bottom.
There are both health and performance concerns associated with aluminum anode rods.
If they connect the anode and cathode and create a short circuit, the battery can fail, break or even explode.
To make the LEDs emit light,the voltage is conducted through the anode and cathode.
The anode film made of Tantalum Powder has stable chemical properties, high resistivity, high dielectric constant and small leakage current.
Then wear masks and gloves to brush, move carefully,to ensure that the anode have no scratches.
And with using cathode and anode to speed up electrons, image high quality and sturdiness stay a big downside for these devices.
This is calledanodizing because the part to be treated forms the anode electrode of an electrical circuit.
In this cell, brine(concentrated sodium chloride solution)is electrolysed between a liquid mercury cathode and a titanium or graphite anode.
He was an early investigator of discharge tubes, the discoverer of anode rays, and is sometimes credited with the discovery of the proton.
When discharging or self-discharging, α-PbO2 may be used as the seed crystal(nucleus) of PbSO4 to form compact PbSO4 crystal,which is the same as the anode.
Second, they're significantly lighterthanks to the fact the positive end of the battery, the anode, is made from lithium, instead of graphite.
Toshiba's current SCiB™ employs a lithium titanium oxide anode, and is known for excellent operating characteristics in respect of safety, long life and rapid charging.
The thyristor consists of a four layer PNPNstructure with the outer layers are referred to as the anode(P-type) and cathode(N-type).
It is obtained as a byproduct of the processing of these ores, from the anode mud of copper refineries and the mud from the lead chambers of sulfuric acid plants.
Both the anode and cathode are immersed in a solution that contains a dissolved metal salt- such as an ion of the metal being plated- and other ions that act to permit the flow of electricity through the circuit.
Once the threshold voltage is exceeded current will be allowed to flow from the anode to the cathode but the diode will block current flow from the cathode to the anode under most conditions.
According to the 20-kilogram calculation of the battery negative material of each hybrid car, the four million hybrid vehicles, each equipped with three batteries,will drive the production scale of 240,000 tons of anode materials.
This means that the silicon anode could theoretically store over 10 times the energy of graphite, but expansion of the anode during charge is a problem.
In the early cold cathode vacuum tubes, called Crookes tubes, this was done by using ahigh electrical potential of thousands of volts between the anode and the cathode to ionize the residual gas atoms in the tube.
During the charging and discharging process, the carbon anode does not generate dendritic lithium, thereby preventing the battery from being damaged due to internal dendrite lithium short circuit.
This prototype, in which the anode material itself contains no lithium, and lithium ions migrate from the LiCoO2 cathode into the anode during charging, was the direct precursor to the modern lithium-ion battery(LIB).
What if the distance between cathode and anode were less than the average distance an electron travels before hitting a gas molecule, a distance known as the mean free path?
For the existing tank, MMO/Ti linear anodes and grid anodes cannot be used, impressed-current anodes should be usually deep-well anode and traditional distribute anode.