Examples of using Internal diameter in English and their translations into Vietnamese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Internal diameter: 80mm.
Q8. what is the Internal diameter?
Internal Diameter At 75mm.
The first update is to the internal diameter categories.
Internal diameter of coil.
There is a gradual decrease in the internal diameter of the bronchi;
Internal diameter at top: 304mm.
NPT fittings are based on the internal diameter(ID) of the pipe fitting.
Internal diameter(mm): Phi 76mm.
Stator with same slot width and internal diameter can share one tooling.
Tape internal diameter: 25mm or 75mm.
The internal diameter of sample support ring is approx.
Upstream: allow a minimum straight pipelength at least 10 times the internal diameter of the pipe.
Internal diameter of the exhaust connection 1: 24 mm.
This method is used when the internal diameter of the body is much larger than that of the mouth.
Internal diameter G6 recommended matching shaft G6: for high precision.
Stator with same slot width and internal diameter can share one tooling, stroke of both ends of….
These Holtests are versatile,self-centering three-point internal micrometers for the accurate and efficient direct-measurement of internal diameters.
Shower room with internal diameter of 750mm, with sliding plexiglass doors.
Continuous winding type, applicable to thickness of 3-20mm, internal diameter of 8mm or more, and external diameter of 200mm or less.
The nominal internal diameter of the brake hose shall fall within one of the following values.
The aim of this unit is to test whether the internal diameter of the tested sample is within standard or not.
If the internal diameter is 25mm and the rotating speed is below 30000r/min, it can be sealed with high speed grease.
If you can send us a pressure drop chart ora list of available sizes(length and internal diameter along with necessary upstream and downstream distances are fine, we can estimate the pressure drop from these data), it would be helpful.
Cable internal diameter is 6.0mm with 7 picecs stainless steels inside and covered with wear resistant soft rubber.
Within 90 minutes, the internal diameter of the blood vessels, on average that has been cut by almost half.
The length and internal diameter of capillary in combination with the fill fluid viscosity create resistance, driving up system response time to unacceptable levels.
Within just 90 minutes, the internal diameter of those blood vessels had on average been decreased by almost half.
Stator with same slot width and internal diameter can share one tooling, stroke of both ends of expanding blades is synchronous, no need two times expending, and expending blade stroke can be adjusted as per requirement;