Examples of using Is to be installed in English and their translations into Vietnamese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Where the instrument is to be installed;
The heater is to be installed via a threaded port in the tank or vessel.
This is the level of humidity in the air,in the room where wooden flooring is to be installed.
Msgstr"%s, which is to be installed, conflicts with%s\n".
Furthermore consider the height of the shower head if it is to be installed high on the wall.
If the washer is to be installed on an upper floor of the house, install a washer pan with a drain to prevent damage in the event the washer leaks or overflows.
After an initial successful test this year,the first MULTI 2021 is to be installed in Berlin.
(a) Intrinsically safe electrical equipment is to be installed independently against general electrical equipment.
Additionally, the NEC states that it mustmeet the temperature requirements of the specific application in which it is to be installed.
(Note 6) For optimum performance,if only one PCI Express graphics card is to be installed, be sure to install it in the PCIEX16 slot.
If the carpet is to be installed in the living room or the children's room, then mid-tone will be a wise color choice simply because it will reduce the need to vacuum daily.
Wherever sand exceeding 2 ppm exists in the water,a Hydrocyclon filter is to be installed before the main filter.
Selection of Components If a new information system is to be installed in a company, the technical components, software and hardware, must be procured first of all.
Stainless steel is another option,especially when the compressed air system is to be installed in a corrosive environment.
If a dryer is to be installed nearby, make sure that there's adequate space for it and that the washer's water supply and electrical connections won't interfere with the dryer exhaust duct.
Within the RAM socket the old one is to be removed andnew one is to be installed to complete the process.
Since the smart lock is to be installed on the interior side of the door, it is safe from being exposed to intruders and is likely not to be tampered with in your absence.
This means that the operating temperature of the motor(and its enclosure) or another component cannot be greater than the lowest ignition/combustion temperature of the gases ordust in the atmosphere where the component is to be installed.
The Enterprise Air Surveillance Radar(EASR)is a new design surveillance radar that is to be installed in the second Gerald R. Ford-class aircraft carrier, John F. Kennedy(CVN-79), in lieu of the Dual Band radar.
Stated by NEC the operating temperature of the equipment(and its enclosure) or other components cannot be greater than the lowest ignition/combustion temperature of the gases ordust in the atmosphere where the component is to be installed.
An automatic nitrogen make-up system is to be installed to prevent the tank pressure falling below 0.07 bar gauge in the event of product temperature falling due to ambient conditions or malfunctioning of the refrigeration system.
The requirements of the windows are somewhat different from the original EFI systempartitions as it urges the users that the boot loader is to be installed in the first partition of the drive which is definitely not the requirement of the original EFI system partition.
The SCADA/DMS system is to be installed and ready for operation by September 2016, and is expected to remarkably improve the availability and efficiency of the distribution networks in 21 cities and provinces in the southern region of Vietnam as well as reduce power losses.
Two LED arrays are to be installed in cells housing SCP-905.
Systems are to be installed across 848 HDB blocks and 27 government sites.
(2) Cables are to be installed sufficiently apart from decks, bulkheads, tanks and each kind of pipe.
If storage and solar are to be installed together, then the interconnection studies canbe done at one time and one comprehensive interconnection agreement can be entered into.
The most suitable windows regarding all the dimensions according to the house androoms where these windows are to be installed, has to be selected now.
Building elements like walls, beams and vertical support structures can be 3D printed right at the site whereas the other elements like doors and windows,electrical and plumbing systems are to be installed with the help of conventional methods.
Users of this platform will be able to obtain their own cryptocurrencies during the CryptoSolarTechICO in a farm where around three thousand equipment are to be installed” says Alain Aguirre, co-founder and director of the mining operation.