Voorbeelden van het gebruik van Nominal current in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Holding torque(at twice the nominal current).
The nominal current of the device is 1.2 A.
Holding torque(at twice the nominal current): 1 mNm.
The nominal currents apply for an ambient temperature of 40 °C.
Xl= multiple of the nominal current/tripping factor.
DC applications: three to six times the nominal current.
Nominal current transformation together with multiplication ratio.
AC applications: five to ten times the nominal current.
It supplied a nominal current of 10 mA at temperatures above 10 °C.
AC applications: three to five times the nominal current.
Lower nominal currents are protected by other protective devices. Key.
DC applications: five to twelve times the nominal current.
The nominal current of the device is 600 mA. Downloads Technical data Price.
With electronic locking of the set nominal currents.
electronic locking of the set nominal currents.
The starting current is a maximum of 1.2 times the nominal current.
RCB1A 1.1(from the table for nominal currents and internal resistances of thermomagnetic circuit breakers).
marginal higher than nominal current.
as a minimum, strict respect of the rule of capping at 4% nominal current primary expenditure growth in central government for the years 2003 and 2004, and may also require additional discretionary measures.
For system extensions, the static boost supplies up to 125% of the nominal current.
For stationary appliances installedSocket required nominal current(single phase) or three-phase socket.
Two phase, 24 steps per revolution Productdetails Data sheet Holding torque(at twice the nominal current).
The cable's nominal voltage is 230 volts, the nominal current is 16 amps and the max.
are supplied with constant current power packs that operate well below the so-called nominal current.
The new products have permanently set nominal currents of 1 and 8 A.
electronic locking of the set nominal currents.
Constant voltage drivers work with a voltage that is just enough to put the nominal current throug the coil of the steppingmotor.
If for example the steppingmotor has a coil with a resistance of 5 ohm and a nominal current of 1 Amp.
Special output characteristics allow a current which can be up to 1.7 higher than the nominal current without switch-off with the voltage being reduced at the same time.
Starting current in the electric supply stays below the nominal current of the motor.