Voorbeelden van het gebruik van Nominal thickness in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Nominal thickness of glass pane e.
Tolerances for a nominal thickness of: mm.
The nominal thickness of the glass pane;
Special tolerances for nominal thickness mm.
The nominal thickness of the layer of glass;
The material may show variations in thickness by+ or- 10% of the nominal thickness.
The nominal thickness of the interlayer or interlayers;
Resistors for our products Matching resistors to our products in various nominal thickness.
Elcometer 307 nominal thickness is only 2- 25mm.
No sheet among those selected in accordance with 11.1 and measured as described in 11.2.3 shall deviate from the nominal thickness by more than± 8.5.
The nominal thickness of the gap between the two glass panes.
of products of the same steel grade, nominal thickness and coating mass.
The nominal thickness of movable partition wall is 100mm.
Tinplate and blackplate are normally available in any nominal thickness which is a multiple of 0-01 mm from 0-15 mm up to
The nominal thickness of strip shall bo 0-50 or 0-65 mm.
The paper stock is almost twice the thickness of regular chart paper to give greater rigidity for more convenient handling- nominal thickness 0.5mm 20 mils.
The nominal thickness of the products is 0.50
fraction thereof, for products of nominal thickness> 25 mm. Page 3.
The nominal thickness of the layer(s) of plastic material acting as interlayer(s);
The permissible deviation in nominal thickness within an inspection unit is± 8% of the nominal value.
Note: nominal thickness of a plate/strip is sum of base plate thickness and coating thickness. .
T quality FeE 310 KR strip to EURONORM 120, nominal thickness 3.5 mm,
A nominal thickness of no less then 1,5 mm for dilution tunnels with inside diameters of equal to or less than 75 mm;
Or 10 mm for nominal thickness e« 50 mm 10 mm for nominal thickness e> 50 mm The requirements of EURONORM 21,
Their nominal thickness may deviate by a maximum of 5 mm in the case of a maximum nominal thickness of 15 mm,