Voorbeelden van het gebruik van Short-circuit current in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Cannot break short-circuit current.
The short-circuit current of test power>
Very good dissipation of short-circuit currents.
Short-circuit currents should be reliably shut down in the milliseconds range.
only on the short-circuit currents.
To prevent large short-circuit current burn failure point.
Contact burns when breaking a large short-circuit current.
Measure load flows and short-circuit currents in the distribution network and synchronization response.
Opening, closing the rated current, and breaking the short-circuit current.
Easily and quickly calculate short-circuit current at the machine's infeed.
over-loading current and short-circuit current.
Calculation of thermally permissible short-circuit currents, taking into account non-adiabatic heating effects.
Together with prescribed short-circuit equipment, they have a conditional rated short-circuit current.
Compared with the two, the short-circuit current is several hundred times different from the breakdown current. .
RCD-D- protective devices with integrated protection against short-circuit currents or overcurrents.
the sum of the short-circuit currents supplied by each side flows into the differential relay, and the differential relay operates.
and multiple short-circuit current switching occasions.
Power balance, calculation of short-circuit currents, calculation of protections
This is different for values like power, voltage, short-circuit current and open-circuit voltage.
However, it cannot disconnect the short-circuit current, so it is generally used in series with a high-voltage fuse,
high-voltage constant current source, no-load voltage is -15000V, short-circuit current is 30mA.
High voltage digital insulation resistance tester output short-circuit current can be measured directly,
the malfunction of the protection system causes the transformer winding to withstand the short-circuit current for too long.
That's why the expected minimum and maximum short-circuit current at the machine's infeed(RMS value in kA)
there is no big short-circuit current to burn the fault point.
The load switch does not need to break the short-circuit current, so it is not equipped with protection device and automatic device, and basically does not use remote operation;
industrial installations with the possibility of overflow short-circuit current and electrical equipment.
When the transformer is subjected to the impact of short-circuit current or in the course of transportation, it is possible to have the phenomenon of winding deformation,
power systems with higher short-circuit current as purpose of power controlling/ reception/ distribution.
other equipment by the short-circuit current.