Примеры использования So designed на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
A package shall be so designed that, if it were subjected to.
E-deckis so designed that the slab formwork panels are compatible withMODULAR universal formwork.
The child restraint shall be so designed and installed as.
The ramp shall be so designed that excessive forces are not required to operate the ramp.
Anchorages for safety-belts shall be so designed, made and situated as to.
Люди также переводят
The ramp shall be so designed that excessive forces are not required to operate the ramp.
The gas-tube pressure relief valve shall be so designed as to open at a pressure of 3,200 100 kPa.
The vent shall be so designed that the penetration of foreign substances is prevented under normal conditions of transport.
As far as practicable,the outer layer of the package shall be so designed as to prevent the collection and the retention of water.
Closures shall be so designed that they will remain secure and leakproof under normal conditions of carriage.
Gas-tube pressure relief valves of Class 0 shall be so designed as to open at a pressure of 1.07 WP of the pipe+- 100 kPa if needed.
Ii be so designed that when the load compartment has been closed and sealed the device cannot be removed without leaving obvious traces.
The device must be so designed that no light is emitted.
The vent shall be so designed that the penetration of foreign substances or ingress of water is prevented under normal conditions of carriage.
An immobilizer and its installation shall be so designed that any equipped vehicle continues to meet the technical requirements.
The pump shall be so designed that the outlet pressure never exceeds 3,000 kPa, when there is e.g. blocking of the tubing or not opening of a shut-off valve.
Closure devices for removable head drums and jerricans(1H2 and 3H2)shall be so designed and applied that they will remain secure and leakproof under normal conditions of carriage.
A package shall be so designed that there will be no rupture of the containment system following performance of the enhanced water immersion test specified in 6.4.18.
The component of the front protective devices shall be so designed that all rigid surfaces facing outwards have a radius of curvature of not less than 5 mm.
Ii it shall be so designed as to eliminate so far as possible all risk of its being put on incorrectly; however, it shall be capable of being worn inside out;
Front fog lamps shall be so designed as to provide illumination with limited dazzle.
A package shall be so designed that, if it were at the maximum normal operating pressure and subjected to.
The protective device shall be so designed that it is necessary to put it out of action in order to enable.
A package shall be so designed that if it were subjected to the tests specified in 6.4.15, it would prevent.
Hatch covers andtheir supporting beams shall be so designed that they cannot be shifted accidentally by the wind, by tackle used for loading or moving the vessel, etc.
This device shall be so designed that measurements are possible without the necessity of entering the spaces to be checked;
A composite IBC with a fully enclosing outer casing shall be so designed that the integrity of the inner receptacle may be readily assessed following the leakproofness and hydraulic pressure tests.
A heated system shall be so designed that it meets the performance requirements set out in this section when tested using the procedure defined.
The child restraints incorporating inflatable elements shall be so designed that the conditions of use(pressure, temperature, humidity) have no influence on their ability to comply with the requirements of this Regulation.
A heated system shall be so designed that it meets the performance requirements set out in this paragraph when tested using the procedure defined.