Приклади вживання Four beads Англійська мовою та їх переклад на Українською
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Th row: four beads.
Only in this case the wire extends after every four beads.
Eighth row: four beads;
The scheme of the heart shows that it turned out a real cross of four beads.
We take four beads, string them.
The twelfth row- four beads;
Put four beads on one end of the working"thread" and pass a second tip through them.
The eighth layer will need four beads. The ninth- three.
We collect seven more beads and we deduce a wire already through four beads.
To do this, strung on wire four beads orange color and form one loop.
That is, after a string fastened to her need to wear two to four beads.
Again, four beads, but white in the middle extreme bead, acting circles.
Take otrez wire, its length will depend on the scope of craftworks,and type four beads.
On gaining four beads thread and a needle through the first stretch, so as to form a ring;
It is important not to forget that the corners of the crosses do not consist of four beads, and of the three.
Move the four beads to the nodule, then a large bead hooks and knit an air loop.
We thread the thread into two needles, and string four beads onto one of them, pushing them down the thread.
After that,we separate three elements and push one end of the metal thread through four beads. Get the loop.
And again, we will string four beads, passing into the third of them from the place where the line comes from.
Twist the long end of a short, strung with beads of,create a reverse number nine and four beads.
Then on the middle four beads are threaded, through them the other end of the wire is passed and everything is pulled together.
Weave petals and flower on the segment assemblywire length of about one meter need to make a small loop over the edge andstrung four beads, and the other end to twist the loop larger size, as shown on the following photo.
To do this, we select four beads and we will weave a rectangle of this size so that we can wrap it around the middle of the bow.
The next series is also lagging, only reduced by four beads before reaching the top, this reduction must be made on each side.
After this, you must put four beads on the wire and stretch the second end of the metal thread through all the beads of the row in the opposite direction;
Further, each of the wire ends must be strung four beads, two tip connect with each other and four beads strung orange.
After this, you need to string on theWire four beads, then wrap it back into 3 beads, which are located in the loop and tighten tight.
On the line, four black beads are collected.
At the top of the workpiece in the photo weave four white beads in a circle.
Now we string four more beads, andPass the needle in the third of them from the place where our fishing line comes from.