Примери за използване на Control signal на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Lumic's transmitting the control signal.
Traffic control signals by the authorised officials.
HDMI can also transmit control signals.
Control signal: Switch output, the maximum load 250 V AC 3A.
Martha's not responding to her control signal and she's flying below radar range.
Control signal: Switch output, the maximum load 250 V AC 3A(optional).
Thermoelectric valve actuator 24 V DC, control signal 0- 10 V, modulating.
Control signal: Switch output, the maximum load 250 V AC 3A(optional).
Transmit HD image,audio and control signals over long distance.
Control signals designated the user's wish to switch between windows or close them.
Robust data transmission to ensure no data or control signal is lost.
She bombards control signal drone is a great signal. .
Their main application is in the transmission of control signals for servomotors.
Ø Support UTC, control signal& video stream transmit through one single coaxial.
Set the proportional relationship between the control signal and the motor speed.
An ordered group of data and control signals transmitted through a network, as a subset of a larger message.
A single 20-pin multi-connector accommodates S-Video and RS-232C control signals.
Provides the transmission of control signals, stereo sound and three video signals. .
Output 4 channel relay switch signal andtheir synchronous DC 0-10V control signal.
It can receive the DMX-512 standard digital control signal which is internationally widely used.
Support separated switching mode on high speed signal and embedded control signal.
It is necessary to check the presence of control signals that are received through the block gate buses.
Output 4 channels AC MOSFET phase cut signal andtheir synchronous DC 0-10V control signal.
It is necessary to check the presence of control signals that are received through the block gate buses.
The control signals will reach the receivers regardless of prevailing lighting conditions, receiver location or obstacles.
It is used to test the transmission of control signals for audio-Video equipment from the ERM controller.
Control signals are then sent from the system to the electric motor, which helps the truck compensate for the disruptions the sensors register.
Also at the very end of the oscilloscope is checked for the presence of control signals that are fed to the bus gate of the key block.
But when the control signals in one of these cells goes wrong, and its life cycle becomes disturbed, it divides and divides.
You can always add an extra mechanical emergency key which bypasses the control signal from the device so it can be controlled manually from the panel.