Примери за използване на Molten metal на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
It is located above the molten metal.
The molten metal solidification is not formed in time;
It is located above the molten metal.
As this molten metal flows, it does something special.
Solder should form a ball of molten metal.
I am Vulcan,god of molten metal, of the artisans.
The girl chosen was thrown alive into the molten metal.
In this case, the molten metal will be pushed out, forming a wave.
But the layer below that is an ocean of molten metal.
They are obtained by molten metal alloys by rapid cooling method.
The blast wave will incinerate that city into molten metal.
Okay, here we go. Molten metal in the basements of all three buildings(WTC1,2 a WTC7).
The gap must be completely filled with molten metal.
It improves the molten metal fluidity, and enhances cleanness of the surface.
Notice the"cut" shape andthe melted… or"Molten Metal".
Before pouring molten metal, it is necessary to remove slag from its surface.
The ground seemed to become as soft as wax or molten metal.
You must introduce the scalpel into the molten metal, exactly half a centimeter at a time.
So I'm looking through the official reports,what do they say about the molten metal?
Such gloves will not allow splashes of molten metal to get on your hands.
By causing the precipitation of gas that was previously dissolved in the molten metal.
Most often, thermal burn eyes caused by steam, molten metal, fire, water or boiling fat.
The muffle furnace is already a rather serious equipment for obtaining high quality molten metal.
They responded by filling bombs with crude oil, molten metal, chemicals and excrement.
Normally, bubbles in molten metal are highly buoyant in the high-density liquid and rise quickly to the surface.
To him cut through a special groove- gate where molten metal is poured.
Pressure casting is to make the molten metal fill the mold cavity under high pressure and high speed and die-casting.
The same activity can play a bad joke if the molten metal gets water.
Cooling- After the mold has been filled, the molten metal is allowed to cool and solidify into the shape of the final casting.
The molds used in metal casting often coat barium with sulphate to prevent adhesion to the molten metal.