Примери за използване на Solute на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Solute in Water%≤.
Material: solvent and solute.
You have more solute out here than you have in the filtrate that's going through the tubules.
And a solution has a solvent and the solute.
Bone is an ideal surface for crystalline solute particles to adhere and grow.
The substance that is usually in smaller quantity andthat dissolves in the mixture is known as solute;
TOC values of aqueous extracts,weight of the solute and calculated percentages, if measured.
The use of pectins is based on its high capability to form gel in the presence of Ca2+ ions or a solute at low pH.
Holding the pressure, the addition of solute decreases the chemical potential(an entropic effect).
And whatever there is less of, so the more water is the solvent and in that case, that is the in this case, that is the sugar-- that is considered the solute. this is the solute, so the sugar.
Ppm is a representation of the solution concentration(solute mass fraction) and ppm indicates parts per million.
Convection can promote dendrite fragmentation due to extreme local temperatures as well as composition variations andpromotes diffusion of solute.
Meaning that the solution inside the cell has a greater amount of solute than the solution the cell is in.
This formula applies when the solute concentration ultram mechanism of action is sufficiently low that the solution can be treated as an ideal solution.
In an isotonic environment, the relative concentrations of solute and water are equal on both sides of the membrane.
But if we add solute to one compartment, it will affect the likelihood of water molecules moving out of that compartment and into the other- specifically, it will reduce this likelihood.
Additionally, the weight loss of the sample(calculated as the weight of the solute divided by the weight of the initial sample) should also be given.
When adding a small amount of solute atoms, the atomic distribution in the matrix dislocations largest accumulation region, thereby reducing the lattice imperfections within those areas of flexibility.
May result from prolonged heating, addition of an electrolyte, orfrom a condensation reaction between solute and solvent; an example is the setting of a gel.
For solution: 1/1000 ml of solute in 1 liter of aqueous solution,its concentration(solute mass fraction) is 1 ppm.
Osmosis- This is a process observed in biology when a solution crosses a membrane into a solution with a greater amount of solute, in response to the differing concentrations.
During the concentration process of materials, solute or impurities are often deposited on the heated surface to form a scale layer, which affects heat transfer.
Order for the device in the smelting process can sufficiently eliminate raw materials into the gas along the scanning direction and lower solute segregation zone scanning speed has to be sufficiently low.
In traditional osmosis a solvent naturally moves from an area of low solute concentration(high water potential),through a membrane, to an area of high solute concentration(low water potential).
When two liquids of different concentration are separated by a semi permeable membrane,the fluid has a tendency to move from low to high solute concentrations for chemical potential equilibrium.
When two liquids with different concentrations of a solute are separated by a semipermeable membrane,the fluid has a tendency to move from low to high solute concentrations for chemical potential equilibrium.
At very high concentrations van't Hoff's law cannot hold, for the osmotic pressure of a solution approaches infinity as the percentage of solvent approaches zero,while the osmotic pressure calculated from the van't Hoff equation never exceeds a few hundred atmospheres even when we approach the condition of pure solute.
For instance, if the fluid inside a cell has a higher osmolarity,concentration of solute, than the surrounding fluid, the cell interior is hypertonic to the surrounding fluid, and the surrounding fluid is hypotonic to the cell interior.
Mainly through solid solution strengthening molybdenum substrate was dissolved in a small amount of Zr, Ti, C and other elements, the crystal lattice of molybdenum contorted,solvent and solute atoms of elements the atomic size of the larger the difference factor to enhance the better, zirconium, and the size difference factor of molybdenum +14.3 size of titanium and molybdenum difference factor of +4.4, the size difference between carbon and molybdenum factor of -34.5, thereby zirconia solid solution strengthening effect of Mo better than titanium.