Примери коришћења Cross section на Енглеском и њихови преводи на Српски
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
Cross section is ovoid.
Moreover, their cross section can reach 4 mm2.
Cross section of the tower and the church from Thurah's Hafnia Hodierna.
This is how the wire cross section and power are connected.
The cross section of the material should be equivalent to 20x40 mm.
This will immediately tell you what the cross section of the slats is.
Wire cross section for wiring.
Single channel flow(specific cross section energy, overflows).
Radar cross section σ is as defined as.
All of you, in theory,should represent a cross section of the community.
Wire cross section, power and permissible current.
Stationary are used for pipes with a cross section of more than 10 cm.
Figure 2- Cross section through transformer cells.
The best fit wooden bars with a cross section of five centimeters.
The cross section is sometimes round and sometimes square.
The tunnel in the centre of Sofia has a cross section of 258 square metres.
The cross section of the used blanks is equal to 20 mm or less.
The compact plastic construction produces a very low radar cross section.
The digital 2D cross section thickness or depth of a CAD model.
Below is a numerical simulation in which a stalling wing is seen in cross section.
Their work item has a cross section like half or a quarter of a circle.
Cross section of the underground building looked when the reactor was operating.
However, how is the wire cross section and power related to this? Directly!
Usually sufficient for a minimum of such marks by wire cross section 0.5 or.
Such a cross section similar to the tube, with its member with the two sides.
If you take aluminum wire, then its cross section should be somewhat larger.
The cross section on it allows us to consider frequent thin annual ring marks, different in width and forming a chaotic speckled pattern.
In addition, this solution is limited to the cross section of the hollow chamber block.
In fact, the wire cross section and power are connected by a pair of simplest formulas.
The cause of an overload is usually too low a line cross section or too weak a fuse.