Примери коришћења Number of turns на Енглеском и њихови преводи на Српски
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
Mm The number of turns is 2.
This is true if there is a straight coil with a large number of turns of a suitable cord.
The number of turns is 300.
An additional device for counting the number of turns may also be useful.
This number of turns will allow to drill.
The E1 and E2 are the voltages, and T1 andT2 are the number of turns on the primary and secondary winding of the transformer.
The number of turns"z" is calculated using both formulas.
First you need to determine the number of turns for 1 volt, using the formula.
From the equality of power in the windings,it follows that the currents in them are inversely proportional to the number of turns.
The optimal number of turns is 25 in each direction.
For self-made devices in the process of winding windings, it is necessary to make taps and change the number of turns.
To calculate the number of turns of the primary winding, you can use simple formulas.
To reduce the current by a factor of 2-3,it will be necessary to greatly increase the number of turns of the initial winding.
And the ratio of 50/ 0.89 is the number of turns of the secondary winding of the welding transformer.
And the main thing in the process of calculating the transformer is to prevent an insufficient number of turns of the primary winding.
Each game consists of a limited number of turns, They are representing the two-time football game.
Sometimes you do not have to kill enemy leaders;instead it is enough that you survive for a certain number of turns, or pick up a particular object.
You only have to change the number of turns of the primary winding in order to achieve the required power.
If you are dizzy from spinning around,try spinning the opposite direction for the same number of turns that got you dizzy in the first place.
With it, you can determine the number of turns for a certain unit of time(most often the interval is 1 minute).
He then became interested in the structural problem of how to move the blocks independently for an arbitrary number of turns without the cube falling apart.
At low frequencies and within limits,increasing the number of turns N improves Q because L varies as N2 while R varies linearly with N.
This interested him even more in the structural problem of how the blocks can be independently moved for a random number of turns without making the cube fall apart.
The next step is to determine the number of turns per 1 V, which in this case is 50 Hz, divided by 10-11, something around 4.7-5 units per volt.
And if you already have experience of creating transformers yourself,then it is easier to do them yourself, focusing on the number of turns and the operating characteristics of transformers.
The total number of turns n1 is the sum of the number of effective turns n and the number of support turns n2.
This can be done in two main ways:by adding or reeling off the number of turns of the wire, or by changing the size of the air gap in the core.
When using a round core from LATRA, it is prewound with tape insulation and then the wire is directly started to wind on it,distributing the required number of turns over the entire ring.
Then it is necessary to determine the number of turns W1= U1/ n, divide 210/ 0.9 and as a result you will get 200-300 turns depending on the cross section of the magnetic cores.
Yes, and to make a mistake in choosing the diameter of the wiring and the number of turns is too simple, so you should not take such a step.