英語 での Current loop の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Current Loop Consumption.
MA Current Loop Products.
Display interface of scoreboard RS232, 0~20mA current loop.
Current loop power≤ 2VA.
To then turn auto-follow back on, simply reselect the current loop.
Can current loop be used?
(0~7ch) Voltage adjustment is available using a 4-20mA current loop.
Current Loop Consumption≤1VA.
Supports direct Peer-to-Peer Current Loop connections from the PC serial port.
Current loop:20 μs(minimum setting).
We keep the trace away from the high current loop(Figure 7) and the inductor L1.
Current Loop/Arc Detection Circuitry.
The Page Left/Right Buttons. To then turn auto-follow back on,simply reselect the current loop.
AN-18: Current Loop/Arc Detection Circuitry.
That EAOUT signal controls the inner current loop and, thus, the inductor current. .
Current loop method(RC-002 is additionally required.).
Internal slope compensation stabilizes the current loop when operating at duty cycles above 50.
Each phase current loop:≤1VA Transportation and storage temperature -25℃~70℃.
This effect canappear to be caused by gain peaking of the current loop at half the switching frequency.
The secondary current loop present in voltage mode usually provides total average current information.
The signal consists of two parts, the analogue 4-20 mA current loop and a superimposed digital variable frequency signal.
Current Loop Products- Maxim Current loops are useful for accurately communicating analog signals over long distances.
Differential mode noise creates a noise current loop, and so the loop area S becomes an important factor.
Because using clamp current transformer measurement,the operators do not need to disconnect current loop, can be measured convenient, and safety.
Simple changes in this current loop are the difference between a good and bad layout.
Through the use of generously rated surge limiting resistors anda fast acting current loop, all units are fully arc and short circuit protected.
To optimize the current loop, the downslope of the inductor current, iL,(the red signal in Figure 2) is made to follow the slope of the sawtooth ramp.
This variable providesaccess to some useful bits of information such as the current loop index and whether this is the first or last iteration through the loop: .
Turnkey motor control modules that provide all the functions required such as speed,position and current loop execution and real-time connectivity to the master, are also available.