英語 での Input signal の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Support 1 group of AV input signal.
The input signal is sampled with the falling edge of CS.
If there are good input signal, AGC LED is green.
The Pinch Effect section adds odd harmonics to the input signal.
Vdc is the absolute maximum input signal the meter can accept.
人々も翻訳します
The input signal in region 406 is a QPSK modulated signal. .
Snapshot Trigger event: motion detection or digital input signal.
Added SENT input signal FastChannelData1,2 setting number.
It sensitively responds to an pulse input signal to the annunciator relay.
Input signal is so small that it requires low noise, precision resistors.
High voltage switching of measuring instruments,protection from extra RF input signal.
The Monitor controls regulate the conditions under which the input signal is heard through the track.
The input signal is a sinusoidal burst that alternates between high and low levels.
ONO SOKKI- TorquemeterFAQ- Do the input signal and output signal have common ground?
Input signal can be taken from contact point and PNP/ NPN transistor open collector output.
Settings Filled Curve Allows you to fill the curves of the input signal and the output signal. .
Rich input signal output interface, may meet computer and all kinds of video equipment.
Fully transparent pass-through operation for fiber wheredelayed output is logically identical to input signal.
If you select"Input", if the input signal can not be locked, IS-miniX will not output any video signal. .
It is a semiconductor device with excellent characteristics,which enables faithful amplification to the input signal waveform.
A 94 dB SPL sinusoidal input signal will give a -26 dBFS peak output level, or a -29 dBFS rms level.
ONO SOKKI- FV series FAQ-Why is voltage still outputted for a short time even though an input signal to the FV-1400 has been stopped?
If the input signal contains a lot of noise and the measurement display is unstable, you may enable the noise filter.
Examples of the former type are found mainly in hardware control,such as time limits on input signal detection or signal output.
If the input signal changes during an ADC conversion, the result would be an average of the input values over time.
Higher hysteresis values reduce"chatter" caused by the gate rapidly opening andclosing when the input signal is near the threshold level.
It works with input signal levels RS422 or HTL and provides a choice of using one or both signal levels for output.
Input Signal/Output Signal Displays the input signal and the output signal of the restored signal. .
In addition, the microphone input signal is temporarily stored as digital data. You can re-display the analysis result in Replay function.