英語 での Machine stops の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
The machine stops.
No fuel, and the machine stops.
The machine stops automatically after the pre-set number of turns has been reached.
The time machine stops.
And then, one day, the network goes down; the machine stops.
The time machine stops.
If a heater element is burned out,an alarm occurs, and the machine stops.
Then the machine stops again.
Do not open door until machine stops.
We could check reasons of the machine stops and could establish countermeasures to raise productivity.
And then suddenly the machine stops.
Without them, the machine stops.
Reliable drying system coordinated with high-speed rotation,it will automatically break circuit when the machine stops.
JDK18-03 Reduce the number of machine stops by countermeasures against falling runners.
It occurs to me, so I'm sure it occurs to you too, that if the machine stops working.
The heating molds will automatically separate when the machine stops, which contributes to protect the material from heated moulds.
Note**(When the machine stops, the pump work 2 hours or so, to protect the vacuum and the whole system, it also mechanical pump).
One day, of course, the machine stops.
Consequently it reduces filling machine stops, raises up-time and avoids eventual damage to packages queuing on your production line.
The heating moulds will automatically separate when the machine stops, which contributes to protect the.
(3) if you machine stops for more than 3 days, please send the ink stack cap below two refill tube with a clip, at the same time some drip into the cleaning fluid in the ink stack cap, so ensure the nozzle surface wet.
With high precision me chanical filling valves,our beer filling machine stops vacuumizing when there are no bottles.
This caused dropped parts and machine stops several times for each pallet. After installing new fittings with piSAVE sense the vacuum level in the system went up to 40-kPa and machine stops could be reduced to a minimum.
You can expect to evade failures of the light guard,and you can secure safety and avoid machine stops and delivery delays beforehand.
The heating molds separate automatically when the machine stops, which contributes to protect the packaging material from the heated moulds.
When the machine stops because of the sensor's reaction, a defective product is very likely to have occurred, before and after the happening. So, when the machine stops, all screws left on the belt conveyor are discarded to avoid defective product flow into the later production process.”.
The heating molds will automatically separate when the machine stops, which contributes to protect the packing material from heated mould.
The system also lets you visualize not only the past utilization rate but also the alarm history and operation history.Causes of machine stops can be pinpointed and analyzed, and improvements can be made.
Cylinder hot sealing,the heating molds will automatically separate when the machine stops, which can protect the packing material from damage, extend the machine's life.