英語 での Main terminal の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Main Terminal.
And below, the main terminal in this file.
Main terminal and auxiliary terminal. .
Looks like though they don't use the main terminal there.
The Main Terminal Building.
The taxi stations are Located at the exit of the main terminal.
There is 1 main terminal building at this airport.
Umeda, Namba,Tennoji Good position of 10 minutes speaking to the main terminal of.
The main terminal has ATMs, exchange offices and a bank.
The function template for the main terminal should be at the top.
The main terminal wiring is as shown in the figure above, where No.
P007017: Main function/ main terminal without parts.
Osaka's main terminal is Osaka station which is situated in Umeda district.
An automated people mover transfers passengers between the Main Terminal and concourses.
The main terminal represents a terminal device on a terminal strip.
The taxi stand is located just outside of thebaggage claim area of the Lower Level main terminal.
Electrical engineering The main terminal represents a terminal device on a terminal strip.
Main Terminal, Level 2,“B” side- at the west end of the building(to the right as you exit the building).
While there were so many passengers in the main terminal,"Midfield Concourse" was relatively calm.
The most 12 number of Lead terminals, Earthing Terminal is provided inside the main terminal box.
P007023: Data of the main function or main terminal do not match the parts data: <x.
You will also come across snack bars, bars, coffee shops as well asfast food outlets that are located in the main terminal area.
There are also daily lots adjacent to the main terminal of the airport. and lots of economy nearby.
The main terminal should normally be assigned to the first function template; if this is not the case, this is reported via a check run.
Open the properties for the main function of the device or the main terminal and bring the Parts tab to the front.
We recommend that only the Main terminal property be used for terminals and that the Main function property not be used.
This means, either increase the value for thenumber of units/ quantity at the main function/ main terminal, or delete the surplus part placements.
This includes The Landing Strip in the main terminal and the Conference room in the Aero park, in block B, with capacity for 30 people. people.
The row numbers of a main terminal and of the associated auxiliary terminals, function templates and/ or accessory parts are grouped in a field.
The marked terminal becomes a main terminal, the part data are copied to the new main terminal and deleted at the original one.