英語 での Measurement values の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Converter measurement values.
Measurement values are displayed on the page.
Deleting measurement values○○.
Memory function 1x199 sets memory of measurement values.
These data are measurement values obtained.
Memory Function 1*199 sets memory of measurement values.
Read the measurement values in the digital display.
Fig.4 Overlay accuracy measurement values.
Measurement values and preparation values are confirmed.
Please select one of five measurement values.
We got these measurement values, but how should we interpret them?".
Why are we getting negative measurement values?" etc.
Measurement values and judgement results can be stored to variables by interpose processing.
Saving the data of the measurement values[csv format]○○.
Coloured screen monitor for the running and interval measurement values.
In the condition above, measurement values can be obtained.
Nissan claims the inspection reports were based on“altered measurement values”.
These data are representative examples of measurement values obtained using specific conditions.
The carmaker added thatinspection reports had been"based on altered measurement values".
Integration of panel to depict measurement values at any location.
Which statistical parametersshould be taken into account for a comparison of measurement values?
MCL View displays measurement values and other monitoring status of each module.(Software installation is required.).
Memory function: 2 x 90 sets of memory of measurement values.
Note: These measurement values determined by Terrior are for cases of ambient air conditions and when not subject to direct sunlight.
Tool to visualize chart definitions and measurement values.
The interface can be used to read measurement values and status information, set operation parameters, and make adjustments.
Plots Tab The Plots tab sheet(Figure 13)displays MAX30003/MAX30004 ECG measurement values and input MUX status. Figure 13.
Measurement values and pulse wave waveforms are displayed on the screen and you can switch the screen from six different patterns as you like.
By setting lower and upper limits on measurement values, alarms can be set and triggered using digital or relay outputs.
The following parameters are important for a comparison of measurement values: arithmetical mean value, standard deviation, amount of single measurements. .