Examples of using Shown in fig in English and their translations into Arabic
{-}
-
Colloquial
-
Political
-
Ecclesiastic
-
Ecclesiastic
-
Computer
As shown in Fig.
The results are shown in Fig. 3.
As shown in FIG. 2, when.
Drawing pyrolysis boiler shown in Fig.
On the map shown in Fig. 23.4, the estimated values are marked by crosses(x).
Driving Shukoff tube is shown in Fig. P12.
For the measurements shown in Fig. 3, an ultrasonic bath with a bottom space of 12x10cm has been used.
The major areas of focus are shown in Fig. 3.
Fill information shown in FIG and enter the(preferably static) IP of the computer cFos Personal Net is running on in the"IP Address" field.
Some experimental data are shown in Fig. 23.5.
The Inspectors note that most United Nations system organizations have chosen two types of top level domain names for their corporate websites,'. org 'and '. int ' as shown in Fig. 2.
The installation scheme for glazing is shown in Fig. 7.15;
For example,"Canadian cabin" or"Norway Cup"-they differ samozaklinivayuscheysya with draft baths cutting system shown in Fig.
Driving Leadership training process is shown in Fig. 16.10.
Basic principles of detection and rejection device shown in Fig. 23.6 and 23.7.
This" white" helicopter has been at the centre of controversy, as it was reported to be previously leased by AMIS and was later leased to the Government of theSudan with the AMIS sign still affixed(as shown in fig. 2).
Direction bias noted on signs, as shown in Fig.
The diagram of the formation of humus substances from the OMS is shown in Fig.
The principle of operation of the detector is schematically shown in Fig. P6 and P7.
The prototype of the electromotive unit for processing cocoa beans, shown in Fig.
The line for the production of bar products is shown in Fig. 7.7.
This transformation is accompanied by a growth of elongatedβ phase at the expense of equiaxed α-phase, as shown in Fig. 1 below.
The changes depending on the duration of baking are shown in Fig. 38.1.
The process of implementation of the project is schematically shown in Fig. 16.7.
Cross-sectional view of the principal part-cylinder-triera shown in Fig. 19.
Installation diagram indicating the critical control points is shown in Fig. 23.1.
There are several variants of continuous technology(general principle is shown in Fig. 19.15).
Next, you will need to make 3 such parts andconnect them with 1 bead, as shown in Fig. 1b;