Examples of using Process temperature in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
Dynamic Process Temperature Compensation DPTC.
What is the minimum and maximum process temperature?
Measurement of appropriate reaction and process temperatures;
By adjusting the process temperatures, the method can also be applied to other plastics such as polypropylene.
Selection criteria for dial thermometers(2): process temperature.
The necessary process temperature is set, as and when required, via the programmable controls in the table housing.
When and when not to use thermowells in process temperature measurement.
Process temperature control issues: The four issues mentioned above are fundamental issues, basic and deep-seated.
Next post When and when not to use thermowells in process temperature measurement.
In particular, companies requiring process temperatures of below 100°C are likely to benefit from solar installations.
Mainly used for measurement and control of industrial process temperature parameters.
Process temperature control problem: the above four issues are fundamental, is the foundation, is a deep-seated problem.
Not only does it measure the flow of electrically conductive fluids,but also their process temperature.
(7) to shorten the processing flow, reducing the heating process temperature and time(including sterilization).
Optimum capture performance depends on the flue gas composition,flue gas treatment system and process temperature.
The resulting higher process temperatures can also reduce the strength of any edge buildup or eliminate it entirely.
One of the most notableadvantages of this system are relatively low process temperatures when the system is operated in heating mode.
In most microelectronic process temperature range, the crystallization rate of the silicon dioxide can be ignored.
The WaveInjector- allowing permanent,reliable and accurate flow measurements at process temperatures from -190 °C up to 600°C and beyond.
Process temperature control problem: the four issues mentioned above are fundamental issues, is the basis of deep-seated problems.
Any other joining techniques(e.g., brazing, welding)need a much higher process temperature that is unsuitable for electronic components and PCBs.
However, its disadvantages are that the process temperature is higher, which makes the process integration difficult, and the degree of residual polarization is small.
Hot workability, refers to thermoplastic, processing temperature range, etc.;
It offers processing temperatures as well as high dimensional stability.
Removing the wafer from the plasma region allows processing temperatures down to room temperature. .
For this reason, an appropriate increase in processing temperature and high-efficiency cooling means in production are effective ways to improve transparency.
This is the oldest process of temperature measurement.