Examples of using Stator in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
Motor 's Stator.
Motor stator: use B class or F grade insulation.
(d) Motor stators:.
These four stator designs can be produced on the same equipment.
BLDC motors(see Figure 3) have a stator and rotor as well;
The stator segments 82 and 84 are therefore also made of electrically conductive metal.
They also contain two fundamental parts: a stator and a rotor.
The stator can be adjusted without limitation to the required distance from the rotor.
Hydroelectric power plants are ready to let the stator of the generator work endlessly.
As the stator current changes to keep the rotor turning, more voltage must be used to overcome inductance(L).
On the other hand,they are used to align the rotor with the stator, enabling an air gap of just 0.05 mm between the two parts.
Stator and rotor interaction to promote the train forward, the train support and guidance system is still using iron wheels.
At the same time, the power consumed by a stator iron will also make the corresponding changes with the change of the voltage.
Another key benefit for a performance-orientedcar such as the Taycan is that a hairpin stator can be cooled much more efficiently.
The field is usually on the stator side and the armature is on the rotor side(opposite or inside-out compared to AC machines).
However, the stepping motor takes three-phase as an example,and has six or four magnetic poles on the stator and the rotor, respectively.
Similarly, the segments 84 of the stator 22 are electrically interconnected with the rotor segments 74 through rotor shaft section 56.
The stresses allowengineers to estimate the number of cycles that the turbine stator can be subjected to before risking failure due to fatigue.
Therefore, when the stator has a control voltage, the rotor immediately turn, that is, with fast start, high sensitivity characteristics.
Ford says the motors are custom designed,and that the larger one cools its stator with oil, which is sent through an oil-to-coolant heat exchanger.
The stators consist of multiphase windings on a laminated low loss iron core comprised of thin layers typically 2.0 mm thick or less;
Hall effect sensors relay the relative positions of stator and rotor such that the controller can switch the magnetic field at the right moment.
The stator, which will be installed in 2020, is the largest piece of equipment to arrive at Darlington since the plant's initial construction.
For permanent magnet 3-phase motors(BLDC, PMSM)rotor speed and/or position information is required in order to keep stator and rotor flux positions synchronous.
ATP synthase includes a stator(stationary part), which arcs around the outside of the structure to help anchor the head to the base(figure 1).
The stator flux vector position must be synchronized with the rotor flux vector position(rather than the opposite) to make the motor operation smooth.
Each of the segments 82 of stator 20 is electrically interconnected through the output circuit 30 with each of the segments 84 of the stator.
To maintain constant stator flux, the voltage and frequency applied to the stator are maintained at a constant ratio, which is the V/f ratio.
The impregnated stator enhances the electrical insulation of the stator windings to prevent chemical or harsh environmental effects and enhance heat dissipation.