Examples of using Stator in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Stator Base Removed.
Effect between rotor and stator.
Of the stator housing remove the stator.
An anchor is installed in this stator.
Cavity mold for the stator packet insulation.
People also translate
Separation impact unit with the rotor and the stator.
Repair of contact between the stator and the reversing switch.
This current always lags slightly behind the field in the stator.
A minute gap between stator and rotor is called air gap.
During start-up, the resistors reduce the field strength at the stator.
Cavity mold for stator packet insulation of the electric motor.
BLDC needle winding machine for stator coil winder.
Top stator guide poz.63 closed impeller motor. stator wires poz.
The air gap is the distance between the rotor and the stator.
It is necessary to disconnect the stator wires and remove the brush holder.
In addition, the carbon brushes are connected to the stator terminals.
The density of pressing of the stator steel is checked similarly to the rotor.
The air gap represents the distance between the rotor and stator.
The coil windings located in the stator are rated to the last turn.
It is made on the principle of a cylinder and has devices for mounting stator windings.
The rotor will turn slower than the stator field, and this is referred to as‘slip.'.
The airgap is generally defined as the distance between the stator and the rotor.
The EMF induced in the stator of the induction motor is given by the equation shown below.
Air gap- The distance between the rotor and stator is called the air gap.
The stator has a core(3) which is assembled from sheets of special electrical steel(alloy of iron and silicon), which has good magnetic properties.
The diagonal impeller with stator ensures high airflow volume and low noise level.
The structure of the tool includes a mechanical unit, the stator unit and control circuits.
Interestingly, the rotor and stator configuration is selected so that the total volume of liquid in the cavities progressively moving always remains the same.
Pen mode switch is connected to the mechanical part and the stator unit, you can proceed to install the handle of the mode switch.
Before starting repair and rewinding, the stator must be cleaned of dirt and removed from the grooves of the old winding.