Examples of using Typical value in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
A typical value is.
V Parameter is a typical value only.
Typical values range from 1% to 10%.
V- Parameter is a typical value only.
Typical values are 15 to 150 milliseconds.
Conditions: Frequency values are typical values.
Typical values are at 25°C, VCC= VCC(Typ).
In composing a deep-belief network, a typical value is 1.
A typical value for a low level of contamination is 150 µs/cm.
The dynamic range is a reference value( typical value), not a guaranteed value. .
A typical value for this scope of supply is around EUR 30-50 million.
The dynamic range is a reference value( typical value), not a guaranteed value. .
Typical values~0.8 generally work fine but can be fine-tuned further.
For Fluke's oscilloscope, the typical value of the dynamic range is 24 channels(3 screens).
Typical values~0.8 generally work fine but can be fine-tuned further.
For Fluke's oscilloscope, the typical value of the dynamic range is 24 channels(3 screens).
Typical value is about 12 to 15 times the rms rated value In.
The maximum value of the ratios was just over 0.78 ounces per day,almost double the typical value.
The typical value of I is 31%, averaged across a large number of projects.
If the sensitivity of the device is higher than the typical value, the sensitivity error will be the increment function of the pressure.
The typical value of I is 31%, averaged across a large number of projects.
The Honor 10 also comes withHonor Super Charge35V/4.5A with the 3,400 mAh(typical value) battery, it can recharge 50% of power within 25 minutes.
The typical value of L is 31%, averaged across a large number of projects we studied.
If the sensitivity is lower than the typical value, then the sensitivity error will be the decreasing function of the pressure.
The typical value of L is 31%, averaged across a large number of projects we studied.
The possible results and typical values observed during such test, depending on material behavior, are summarized in the following graph.
A typical value for the Reynolds number is Re= 10-15, so the assumption undoubtedly holds.
For neurons, typical values of the resting potential range from- 70 to- 80 millivolts;
The typical value of the low-frequency cutoff frequency of the oscilloscope is 10Hz, as shown in figure 4.
The typical value is 46db, if 50dB, then the image with a small amount of noise, but the image quality is good;