Examples of using Can also be set in English and their translations into Czech
{-}
-
Colloquial
-
Official
Can also be set as status output.
The" cause of transmission" can also be set.
The property can also be set by the Dim method.
Additional information such as job number can also be set.
Contacts can also be set as guarded.
The operation speed of the pump(slow or quick) can also be set.
Key rotation can also be set as a policy in MDM.
An automatic restart sequence of 0 to 9 attempts can also be set.
Route preferences can also be set during the initial setup.
The workpieces can be measured directly on the workbench, andthe right angle for the most precise cut can also be set directly.
A/B- The unit can also be set by you to provide two programme.
If the differential pressostat is not present, defrosting can also be set for time cycles using the parameters.
The barrier can also be set up at an angle or in a straight line, so any area can be blocked-off.
The position of the 3-way valve for the optional domestic hot water tank as well as that of the gas boiler's bypass valve can also be set.
The night light(6) can also be set to VOX(voice activated) by pressing button.
The values for stop-losses and profit targets are specified in pips,though the S/L and T/P can also be set to break-even i.e. the order's entry price.
It can also be set to comfort mode, which automatically adjusts the humidity according to the ambient temperature.
To measure or transfer grades,the measuring tool can not only be placed on or against surfaces, but can also be set up or fastened in various ways.
User Account Control can also be set to different levels, so that it warns you more or less depending on the situation.
In order to check that the conductivity measurement is working properly a threshold can be set for each range; a ceiling can also be set for checking the quality of the permeate.
The night light can also be set to be VOX(voice activated) by moving the switch(18) to position Auto.
Datum points can also be set by touching the edges of the workpiece, one after the other with a tool, and manually entering the tool positions as datum points.
Desired temperature, brewing time and power can also be manually set via the digital LCD display.
Statically can be also set by the PmComm object configurator.