Examples of using Pushbutton in English and their translations into Czech
{-}
-
Colloquial
-
Official
Pushbutton control for up and down rolling movement.
Escape release on the rear with pushbutton.
Connect a pushbutton, smoke detector relay, etc.
Depress for about 6 sec. the MFB(5) pushbutton.
Press the pushbutton of the bell(transmitter) to sound the bell.
The thumb that is the longest on the pushbutton, will be the winner.
Pushbutton, switch and signal lamp with plastic body 198.
An AUTOSTART SIGNAL INHIBITS the Engine Shutdown pushbutton.
Keep the adjustment pushbutton that is located to the rear of the backrest pressed in Fig.
With mechanical release,special wiring Blue pushbutton, cover labeled.
Pushbutton=On/Off pressure must be maintained to operate the hairdryer.
Do not expose both the bell unit and the pushbutton to direct sunlight or moisture.
Each pushbutton can store two 25 digit numbers including characters star"*" and hash.
Switching threshold adjustment via potentiometer,or teach-in via pushbutton or cable.
The pushbutton must be released when the‘Engine Running' lamp is illuminated which should be almost immediate.
Is powered by alternating current from the magneto and the pushbutton on the handlebar. Note.
Press the Silence/Lamp test pushbutton for least 5 seconds, the indicators will illuminate for 2s, and will then be extinguished for 2s.
Align the laser point onto the target andactuate a length measurement by once more briefly pressing the pushbutton.
It is designed for mounting into installation box, under the pushbutton or switch directly into existing wiring.
Restraint harness straps and headrest height can be adjusted simultaneously to 6 different positions, by acting on the rear adjustment pushbutton L.
The sequence of functions initiated by a command issued via a remote control, pushbutton, etc. depends on how the control's electronic system has been set.
Some types are equipped with an additional navigation key,a potentiometer with pushbutton function or a touch screen.
To cancel the 1 hour fuel solenoid timer, either press the stop pushbutton or turn the mode switch to the‘off' position at anytime.
A red LED diode will indicate that radio signal was transmitted and that the pushbutton is matched with the bell.
Log ram 2 log guide plates 3 splitting wedge 4 bleed screw 5 transport handle 6 piston rod 7 dipstick 8 cylinder cover 9 supporting foot 10 motor 11 operating pushbutton 12 wheel 13 wheel cover 14 operating lever 15 safety label 16 front support leg 17 middle rod 18 back rod 19 back support leg.
Output function, switch points andmeasuring range are conveniently set via a pushbutton on the unit or via wire teach.