Examples of using Switch box in English and their translations into Czech
{-}
-
Colloquial
-
Official
The switch box up there.
To connect the PC cable to the switch box Prerequisite.
Put the switch box back into place.
Remove the upper front panel, and open the switch box.
Remove the 2 switch box cover screws.
People also translate
Switch box low voltage wiring inlet 3.
To close the indoor unit 1 Close the switch box cover.
Place the switch box lower on the unit.
Remove the 2 screws,unhook and put the switch box aside.
Switch box high voltage wiring inlet 4.
In rare cases, you may also need to remove the switch box.
Close the switch box cover of the gas boiler.
The booster heater circuit breaker F2B on the switch box is turned ON.
Open the switch box cover of the gas boiler.
If you have to do work behind the switch box, open the switch box. .
Close the switch box cover of the indoor unit.
See also:"8.1.1 To connect the PC cable to the switch box" on page 49.
Open the switch box cover of the indoor unit.
If you have to connect electrical wiring,remove the switch box cover.
Make sure the solenoid coil is outside the gas boiler switch box.
To open the switch box cover of the gas boiler.
There are NO loose connections or damaged electrical components in the switch box.
To open the switch box cover of the indoor unit.
To access the domestic hot water temperature sensor, the switch box can be tilted.
Reinstall the switch box cover and close the switch box. .
Factory-mounted cable connected to the backup heater contactor inside the switch box(K5M for *6V and *9W models) b.
Fix the cable in the switch box by routing it behind the pre-mounted wires.
Switch box(not shown)- Used on models with electric starter for 220 volt connection.
Reattach the service PCB cover and switch box cover and turn the power back ON.