Examples of using Heat flow in English and their translations into Dutch
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
Mineral Wool good heat flow limits.
The heat flow is up to 6 times higher.
The moisture follows the heat flow only during this phase.
The heat flow obtained by the weighting procedure Q.
They also allow them to better manage the heat flow in their buildings.
Fig.3: Heat flow of a thermocouple placed in a hole.
Elastomeric and polyethylene pipe insulations control condensation and heat flow.
Heat flow in a sandwich panel can be reduced by selecting Prelaq Energy.
Technical drawing of a window joint Isothermal calculations of the heat flow.
Temperature and heat flow are individually controlled in each heating zone.
The figure that matters here is the lowest number of chambers in the direction of heat flow through the profile.
The heat flow through the material was regulated by the relative atmospheric humidity.
It is used to determine the difference in rate of heat flow into the sample and a reference material.
COVRA uses the heat flow for climate control in the processing buildings and the office.
People often approach by reducing the thermal resistance of the heat flow and enhanced convection coefficient to.
Heat flow is a curtain
with which you can set the direction of heat flow, adjust power.
To approximate the heat flow in the left boundary condition(3)
The calorimeter is kept at the same pressure enabling the heat flow to be measured as a measure of enthalpy change.
Geothermal heat flow from dry rock therefore increases,
The optimum capillary diameter for maximum heat flow is in most cases a few tenths of a millimetre.
The Heat Flow and Physical Properties Probe,
This formula can be easily deduced from the law of the conservation of energy and the fact that heat flow is proportional to the temperature gradient.
For the heat flow direction is not to heat the ceiling below neighbors,
This category includes the heat loss through the building constructions in the cold season, the heat flow to the room is in direct sunlight, etc.
the partition in the exchanger has been designed in such a way that the distance the heat flow has to bridge is as small as possible. The permitted pressure drop in the exchanger has been taken into account. The two air flows move(in opposite directions) parallel to one another along the-in principle immeasurably large- partition.
the partition in the exchanger has been designed in such a way that the distance the heat flow has to bridge is as small as possible.
specific heat of the reaction mass, heat flow and reaction enthalpies- resulting in faster process development and safer scale-up.
Thermal bridges- Energy weak spots in the building envelope Technical drawing of a window joint Isothermal calculations of the heat flow: renovated/insulated masonry in comparison to poorly insulated.
the planet's internal heat(geothermal heat flow) or the energy generated by biological processes(bioenergy),