Examples of using Surface roughness in English and their translations into French
{-}
-
Colloquial
-
Official
Finished surface roughness is poor?
Results always depend on surface roughness.
Surface roughness can reach to Ra0.2um.
Smoothes and reduces surface roughness.
Surface roughness up to Ra 0.1/ N3.
People also translate
Degree of fulfi llment Surface roughness max.
The surface roughness can achieve to Ra0.4.
Moreover, one of the unique properties is its surface roughness.
The surface roughness is below 5 nm.
The main differences are the surface roughness and cost of casting.
The surface roughness is 0.6 u CIA.
The door made of AISI 316L with internal surface roughness less than 0.5µm.
Journal Surface Roughness: 0.63-0.16μm.
Efficiency is increase 30%, andacquire excellent surface roughness.
Surface roughness table. N11- N1, Ra, Rz.
Measurement of the surface roughness in the specified region.
Surface roughness Ra value is 0.4μm.
The measurements of surface roughness, height, depth, steps, etc.
Surface roughness is reduced, precision stability improved.
Stones rolled from"extra"quality= without surface roughness and a high purity.
Round, and surface roughness is above Ra0.05( specular.
Determine which types of ice are decayed or have surface roughness.
What is the surface roughness after machining?
It allows us to measure the micro-structure and the surface roughness.
The effect of surface roughness to contact angle.
Good surface smoothness, stable ink absorbability,low surface roughness.
The surface roughness of the shaft should not exceed Ra 4 µm.
Maintenance is greatly facilitated by a reduction in the surface roughness.
The influence of surface roughness is also taken into account.
The Profilometer- Roughness Tester PCE-RT 1200-ICA is used to determine surface roughness.