Examples of using Led should in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
The LED should flash green.
When you press the button, the green LED should light.
The LED should glow red.
Click Apply button, the green Status LED should turn off.
Red LED should turn on steady.
The capacitor buffers the whole a little and the LED should light up longer and more stable.
The red LED should not be illuminated.
There should be resistance on the rotor shaft and the LED should turn on.
Now the green LED should light up.
LED should be green and not flashing.
After a few seconds, the LED should flash green and turn off.
The LED should not light up at all or light up only shortly.
The INFINIUM Tube Life Monitoring LED should now turn off and you can begin playing.
The LED should not light up at all or only shortly light up in case of music peaks.
After that you have to click at Flash on Program and then the LED should blink one second on, one second off.
The red LED should now show solid.
GAIN control until the OUTPUT LEVEL is shown by means of LEDs all green LEDs should light up andthe first yellow LED should do so occasionally.
ImpoRTANT: The Status LED should still be Blue at 6° of cyclic pitch.
The LED should be lighted if you have ordered and correctly configured DSL.
D The Power LED should light up when the Adapter is installed correctly.
The LED should not light up or light up only shortly with signal peaks; if it lights permanently, the signal is overloaded.
For a PsycoBall led should be used 130 degrees in order to get a good color mixing.
The LINK LED should also illuminate solid red as soon as the video link to the receiver has been established.
The red power LED should never blink, because it is hard-wired to the 3.3V power supply rail.
The red'Data' LED should flash at one second intervals to indicate that serial data is being sent from the GPS receiver.
If the red LED should not go on check the cigarette lighter jack or the fuse in the connection plug(2 A, quickaction) for its functionality.
At the same time, the LED should not be operated at its maximum power in order to achieve the required amount of light output because of superior performance decrease in both, efficiency and expected lifetime.
The lead should only be connected to a power outlet that is compatible with the voltage, power and frequency requirements stated on the rear panel.
All leads should be cut to the same length. Strip the ends of each wire.
The tourism sector faces changes, and the countries that lead should undertake actions to maintain that position of privilege, both to create new business opportunities that allow you to differentiate, to promote diversification of markets and consolidate the successes achieved in traditional markets.