Examples of using Logic input in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Associated logic inputs/ outputs.
Logic input for external make contacts e. g.
Connecting the logic inputs and outputs.
Remote operation of dosing(foot/handswitch or logic input)•.
Logic input LI3 Fault reset Analog input AI3 or summed ref.
Remote operation of MemoDose foot/hand-switch or logic input.
Logic input LI1 forward Logic input LI5 ramp switching.
Channel signal conditioner, 24 V DC supply, Logic input 19 V DC….
SAI cannot be assigned if a logic input is assigned to rFC reference switching.
Channel isolated barrier,24 V DC supply(loop powered), Logic input 15 V DC….
A button for connection to a logic input for opening a door inside a building.
Channel signal conditioner,24 V DC supply(loop powered), Logic input 15 V DC….
This can be activated in 2 ways:- by activation of a logic input assigned to this function(state 1)- automatically if the frequency is below 0.5 Hz.
Two references are switched(AI1 reference and AI2 or AIC reference)by a command on a logic input.
PII and PIA cannot be assigned if a logic input is assigned to JOG or to PS2.
Give your next electronics project a sense of rhythmthanks to this SparkFun MP3 Trigger with 18 logic inputs.
Channel isolated barrier, 24 V DC supply(Power Rail),Output 45 mA at 11.7 V DC, Logic input, non-polarized, Up to SIL 2 acc. to IEC 61508pa.
If a logic input LIx is assigned to rFC(reference switching) and AIC is assigned to PII or PIA, the speed reference is taken on AI1 if LIx 1 and is the output of PI if LIx 0.
Or 8 speeds can be preset, requiring 1,2 or 3 logic inputs respectively.
Freewheel stop LI2 to LI4"Switch on disabled"- Set the logic input assigned to the"freewheel stop" function to 1(active at 0)- Perform the transitions required to return the drive to"run" status.
The input value and alarms are frozen while the logic input is closed.
Ammeter outputs/input- 5A at 250Vac/30Vdc relay- 24V, 10V at 20mA logic- triac 20 240Vac, 1A±10%- 5A/250Vac relay only- 5A at 250Vac/30vdc relay- 24V, 10V at 20mA logic- continuous 0…10V, 0/4…20mA- analog 0…10V, 0/4…20mA for transmission, resolution 12 bit- input from current transformer 50mAac,10 Ω 50/60 Hz- logic input 24V, 5mA or from no-voltage contac.
Nd acceleration ramp 2nd deceleration ramp These parameters can be accessed if the ramp switching threshold(parameter Frt)is other than 0 Hz or if a logic input is assigned to ramp switching.
