Examples of using Negative pole in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Usually this is the negative pole.
Negative pole(-) of the vehicle battery.
Start with the negative pole.
In case of vehicles with a supplementary battery, also disconnect this negative pole.
Put positive and negative pole in the right place.
People also translate
Two connectors are required for each LED positive and negative pole.
The battery's negative pole should be facing upwards.
Always start with the negative pole.
The common negative pole of these outputs should be connected to terminal 20.
Connect the BLACK wire(- V) to the negative pole of the car battery.
The negative pole is just there to let you know that the positive is the good one, is the one you want.
Connect black cable to negative pole on new battery.
Is the polarity of the battery connections correct(positive terminal on positive pole, negative terminal on negative pole)?
Put positive and negative pole in the right place!
Insert the batteries into the rear support(16), with the positive pole and the negative pole as printed in the support.
The metal to be protected is connected to the negative pole of a direct current voltage source and forms an electric circuit with an inert anode and the medium.
Power terminal for the connection of the amplifier to the chassis ground or the negative pole of the car battery.
One positive pole and one negative pole allow electrical discharge.
Pin 8 must be connected to the switched positive pole of our battery andpin 4 to the negative pole of the battery.
Connect the negative clamp(black) to the negative pole of the battery or to the car chassis.
Connect the new battery: Connectthe red cable to the positive pole of the battery and the black cable to the negative pole.
The positive pole was the"anode"("upper route") and the negative pole, the"cathode""lower route.
CH 1+ positive pole of speaker,left CH 2+ negative pole of speaker, left CH 3+ positive pole of speaker, right CH 4+ negative pole of speaker, right.
Patented large-diameter with 25mm2,red and black connector distinguish positive and negative pole avoiding wrong operation.
CH 1 L+ positive pole left speaker CH 1 L- negative pole left speaker CH 2 R+ positive pole right speaker CH 2 R- negative pole right speaker.
This product is only approved for the connection to 12 V direct current on-board networks with the negative pole of the battery to the car body.
Then connect the negative clamp(black) to the negative pole(or the car chassis), away from the fuel line.
Start by connecting the cable set to the batteries by firstconnecting the positive pole of the first battery to the negative pole of the second battery.
On vehicles with the START-STOP system,the jump-start cable of the charger must never be connected directly to the negative pole of the vehicle battery, but only to the engine earth.
To connect a speaker: Connect its positive pole(marked core of the speaker cable)to the red terminal and connect its negative pole to the black terminal.