Examples of using Whose thickness in English and their translations into Greek
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Financial
-
Official/political
-
Computer
Made of ABS, can bore materials whose thickness does not exceed 10-20 mm.
The outside of sphere S is covered by a strong insulating material(electrically charged), whose thickness is s1.
This mixture is applied to a layer whose thickness may be up to 30-40 mm.
The sheet material whose thickness is sufficient to withstand various loads easily and lasts as long as possible.
There is micro water channel in a thin cooper heat sink whose thickness is only 1.5mm.
The decorative finishing layer is ultra-thin stone, whose thickness is only 8mm, while the traditional dry hanging stone is 25mm in thickness, so the use of Sinoma panel can save the consumption of stone and steel.
Versatile, just attach the post net in any smooth area whose thickness less than 5 cm.
Use it to cut the glass, whose thickness is less than 1 centimeter.
The heating element of the heater is made of a thin carboxylic yarn whose thickness is 1.5 mm.
In practice, we often refer steel plates whose thicknesses are less than 20mm as medium plates;
If the floor tiles will be laid,it is preferable to use technical insulation of tubes, whose thickness is 2 mm.
Normal paging machine is suitable for products, whose thickness less than 5mm, width less than 300mm.
So, with thousands of years passed, sedimentary rocks have accumulated on this layer of earth, which consist of rock-sand material,coming from Pirin mountain, whose thickness reaches 120m.
Floating ice tongue has a width of 15 km and70 km long, whose thickness varies from about 600 m at the base and about 30-80 meters on the edge.
This chip is drilled out on its reverse side,giving the inside of the chip the form of a pressure diaphragm whose thickness determines the pressure range.
Further around the perimeter of the surface of the glued strip of rubber, whose thickness must not exceed by more than half a centimeter height of the alleged ties.
At the bottom of the trench site located on the street,poured sand layer, whose thickness must be at least 15 cm.
As you may observe in the shape above, the basic difference between anodising andelectrostatic painting is that during anodising, whose thickness ranges from 10-25 μm(20-25μm of which are also called sea anodising), the anodising layer penetrates into the metal and practically does not change its dimensions.
In addition to the above applications of granular copper powder, a large quantity of copper and copper alloy powder is used in flake form, i.e.,as a powder whose thickness is small in relation to its other dimensions.
Much more difficult to work with broadband rolled metal, whose thickness can reach 60 mm or more.
For the insulation of floors is preferably usedplate, whose thickness does not exceed 50 mm.
When this frame is produced by knitting from the metal rods, whose thickness is from 8 mm to 16 mm.
Any pool construction implies that fits the bottom of the sand layer, whose thickness is between 20 and 30 centimeters.
The plastic flakes densifier or agglomerator is used to granulate the thermal plastic films,PET fibres, whose thickness is less than 2 mm into small ganules& pellets directly.
