Examples of using Maximum density in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Water to the maximum density point.
The deep basins are filled with water of maximum density.
The maximum density of water occurs at.
Obtaining the maximum density.
The maximum density occurs at 4°C.
Note on temperatures of maximum density.
It reaches maximum density in less than a minute and lasts longer than 5 minutes.
This is because the water reaches freezing point before the maximum density is attained.
The maximum density of negative film is up to 3.0d(density), while slide film can reach 4.0d.
Like the fact that 4 degreesCelsius is the temperature at which water has its maximum density.
The maximum density of negative film is up to 3.0d(density), while slide film can reach 4.0d.
At the age of 30, bones reach their maximum density and strength, known as your peak bone mass.
It might be reasonable tobelieve that the best gradation is one that produces the maximum density.
Generally, a true maximum density gradation(exactly on the 0.45 power curve) would result in unacceptably low VMA.
A gradation that, when plotted on the 0.45 power gradation graph,falls mostly below the 0.45 power maximum density line.
A widely used equation to describe a maximum density gradation was developed by Fuller and Thompson in 1907.
They observed that particles would eventuallyturn into a low-complexity state of minimum size, and maximum density.
In addition, water has the properties where the maximum density occurs at a temperature of 4° C and not at the point of freezing.
Furthermore, the influence of certain elements such asdissolved salts can lower the temperature of maximum density of water.
This graph uses n= 0.45 andis convenient for determining the maximum density line and adjusting gradation(Roberts et al., 1996[1]).
A gradation that, when plotted on the 0.45 power gradation graph,falls mostly below the 0.45 power maximum density line.
Therefore, although it may not be the“best” aggregate gradation, a maximum density gradation does provide a common reference.
At the age of 21, our bones are at maximum density and after that, especially if you have certain genetic or lifestyle factors, can start to degrade, sometimes significantly, after this.
Rise 10 atmospheres(about kira100 m below the surface) temperature of maximum density of water is reduced by approximately 0,1ºC.
A photographic image that is not composed of halftone dots or, in other words, an image that consists of tonevalues ranging from some minimum density(such as white) to a maximum density(such as black).
Peak bone mass, or when bones reach their maximum density and strength, typically occurs around age 30 for both sexes.
When selecting pure tungsten targets,you should pay much attention to its high purity, maximum density and homogeneous microstructure.
This affects the thermal convection: S< 24.7:The water cools until it reaches maximum density; then, when the surface water becomes lighter(ie after the density maximum has been passed) cooling is restricted to the wind-mixed layer, which eventually freezes over.
This graph uses Fuller and Thompson's equation with n= 0.45 andis convenient for determining the maximum density line and adjusting gradation(Roberts et al., 1996[1]).
It was originally observed thatmixes closely following the 0.45 power maximum density line in the finer gradations sometimes had unacceptably low VMA.