Examples of using Sample solution in English and their translations into Indonesian
{-}
- 
                        Colloquial
                    
 - 
                        Ecclesiastic
                    
 - 
                        Computer
                    
 - 
                        Ecclesiastic
                    
 
System stability should be determined by replicate analysis of the sample solution.
Cm3 of the sample solution was titrated with 0.02molar KMnO4 and 26.3cm3 was required to reach the end point.
A complete multi-element analysis can be comp leted in a period as short as 30 seconds,consuming only 0.5 mL of sample solution.
At the bottom of this page, we provide sample solutions for more exotic themes such as musical instruments or cocktails.
The term system stability has beendefined as the stability of the samples  being analyzed in a sample solution.
Some redox reactions may require heating the sample solution and titrating while the solution  is still hot to increase the reaction rate.
Conductivity/ TDS Meter(other analyzer)is a tool that serves to calculate the particle content of solids in a sample solution.
If a sample solution containing a target antigen concerns the GMR sensor, then a complex bond exists between the target antigen and the antibody.
Paper chromatography is a technique that involves placing a small dot orline of sample solution onto a strip of chromatography paper.
Another specific example is pH probes with liquid electrolyte that need the electrolyte to be topped-up when the levelbecomes close to being lower than the level of the sample solution.
The retention time of the major peak of the sample solution corresponds to that of the Standard solution,  as obtained in the Assay. Conforms.
This is differentiated from calorimetric titrimetry by the fact that the heat of the reaction(as indicated by temperature rise or fall)is not used to determine the amount of analyte in the sample solution.
If the sample solution is in contact with a second solid or liquid phase, the different solutes will interact with the other phase to differing degrees due to differences in adsorption, ionic strength, polarity or size.
Thermometric titrimetry: Differentiated from calorimetric titrimetry because the heat of the reaction(as indicated by temperature rise or fall)is not used to determine the amount of analyte in the sample solution.
Using this approach, even for the first time talking about five years ago,but then began to appear the first experimental sample solutions, which, however, did not become very popular on a global scale.
The expression"1 PPM" means a given property exists at a relative proportion of one part per million parts examined, as would occur if a waterborne pollutant waspresent at a concentration of one-millionth of a gram per gram of sample solution.
Many solutes readily decompose prior to chromatographic investigations, for example,during the preparation of the sample solutions, extraction, cleanup, phase transfer or storage of prepared vials(in refrigerators or in an automatic sampler).
By comparing the absorbance of the sample solution at a specific wavelength to a series of standard solutions  at differing known concentrations of the analyte species, the concentration of the sample solution can be found via Beer's Law.
Flasks can be used for making solutions  or for holding, containing, collecting,or sometimes volumetrically measuring chemicals, samples, solutions, etc. for chemical reactions or other processes such as mixing, heating, cooling, dissolving, precipitation, boiling(as in distillation), or analysis.
Both sample and reference solution are contained in the cells.
This pH meter serves to measure pH in a sample of solution, very easy to use.
This pH meter serves to measure pH in a sample of solution, very easy to use.
And we also support your projects in sample, installatin solution, etc.
Column chromatography is set up with peristaltic pumps,flowing buffers and the solution sample through the top of the column.
TDS Meter(Air Quality Meter)function to test the particle content of solid in a sample of solution.
Sample problem about crushers with solution.
A residue or precipitate in a chemical analysis method can be collected orfiltered from some sample or solution on special"ashless" filter paper.