Examples of using Variable resistor in English and their translations into Japanese
{-}
- 
                        Colloquial
                    
 - 
                        Ecclesiastic
                    
 - 
                        Computer
                    
 - 
                        Programming
                    
 
Variable resistor range.
KΩ B type variable resistor, one.
Wiring is same as previous instruction. You also need variable resistor.
You can't use variable resistor unless in‘CH A'.
By the test pattern is rewritten, it writes to the variable resistor.
CharacteristicsEnclosed variable resistor, panel stopper F-type.
If only two terminals are used, one end and the wiper,it acts as a variable resistor or rheostat.
The DS1859 dual variable resistor serves as the example device.
Why is there no single variable resistor?
Basically, variable resistor value is mapped to a range of from 0 to 1800 in‘AR-FOCUS'.
And for more advanced, I use variable resistor in this article.
The variable resistor has 1 byte register, and the resistance value changes by writing data to the register.
Based on the review, I will write sketch using the variable resistor, first.
In this application the variable resistor changes value every 2°C based on the LUT.
CharacteristicsHigh power enameled glass wire wound type variable resistor(*non-RoHS compliant).
Just like the micro relay, a variable resistor(VR) for the volume control must be of high quality.
The effects of these resistors  are interdependent on each other and the value of the variable resistor.
As it changes shape, it can activate a switch or a variable resistor to control the temperature.
The variable resistor settings are stored in EEPROM memory and can be accessed over the 2-wire serial bus.
The motor characteristics can be changed using a variable resistor connected through the sliprings.
Photoresistor or light-dependent resistor(LDR) or photocell is a light-controlled variable resistor.
A temperature variable resistor(self-restoring type PTC) is adopted as a current control element for maintenance-free operation.
Each device performs the same function as a discrete potentiometer or variable resistor and has 256 tap points.
The temperature variable resistor(PTC) is effective in preventing the I-OCU and B-OCU fuse from being blown out by lightning.
The MAX5128 performs the same function as a discrete potentiometer or variable resistor and features 128 taps and 22kΩ end-to-end resistance.
The variable resistor 3302 acts as a level-adjusting device and is ideally a potentiometer or similar variable-resistance device.
Use of potentiometer If you apply the full voltage to both end terminals of the variable resistor, partial voltage can be obtained from the middle terminal.
The digipot then adjusts the variable resistor by using the modifier in the lookup table that corresponds to the measured temperature.
A variable resistor is a two-terminal digipot variant with the wiper and one end of the resistor  string available see Figure 1b.
Adjustment of the variable resistor is typically performed manually so that a user can tailor the level and aspect of the common-mode gain.