Examples of using Dew point in English and their translations into Malay
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Wind, temperature, dew point.
Dew point, Wind, temperature.
Output temperature≤16℃, dew point td≤-8℃.
Loretta Lee of the peach ripe dew point clip 4.
Finished gas dew point: less than -40 DEG C.
The working humidity of the air is at most 80%, and the surface must beheated at least 3 degrees above the dew point.
ZDG combined low- dew point compressed a….
The dew point: less than or equal to 60 DEG C.
ZDG combined with low dew point air dryer.
The dew point can be reduced to -20℃ or so, but the equipment is large, and the absorption liquid must be replaced.
Optional RS485/RS232, linkage interface and dew point detection function;
Combination type low dew point dryer is low dew point drying equipment in the refrigeration drier and drier for an adsorption.
Through matching and combination, the moisture content of treated air canbe less than 1g/kg of dry air(equal to dew point temperature -60oC).
When the inlet temperature is higher than the dew point of the flue gas above 25 degrees, the bag filter can run efficiently and stably.
Then the low-humidity compressed air enters into the adsorbing barrel,beening further dried and get more lower dew point finished air.
In use,it is necessary to prevent gas from being cooled below the dew point in the bag room, especially when the bag filter is used under negative pressure.
It is necessary to take the cooling measures to the gas above this temperature,and the temperature measures must be taken for the gas below the dew point temperature.
Secondary loop on CDU supply cooling liquid that above dew point to ensure no condensation problem, these cooling liquid will flow through heat source and return to plate heat exchanger.
In 2015, Hangzhou Fuda dehumidification equipment Co., Ltd. and China Institute of Metrology,established the ultra low dew point dehumidifier research and development center.
To prevent dew, the temperature of the gas in the Dust Collector and its system must be kept above itsdew point at 25~35 degrees centigrade(such as the dew point temperature of the kiln mill at 58 degrees C, the operating temperature should be above 90 degrees C), so as to ensure the good use effect of the filter bag.
For the bag filter, its use temperature depends on two factors, the first is the highest temperature of the filter material,and the second is that the gas temperature must be above the dew point temperature.
The dust collector is a kind of dust removal equipment, which is designed for the high humidity,low dew point and high dust concentration by using the integrated mechanism of the principle of inertia collision and the combination of electrostatic adsorption.
First, the compressed air into the pre-cooler for air- gas or air- water heat exchange, removing a portion of heat, then into the hot and cold air exchanger, makes heatchanges with the cooled air which has come out from the evaporator and cooled to a pressure dew point.
Two is the control of gaseous pollutants for gaseous pollutants, mainly by the use of physicochemical properties, such as solubility,adsorption saturation, dew point and selection of chemical reactions, and the separation of pollutants from the exhaust gas.
Because its shell often has air leakage,the bag chamber gas temperature is lower than dew point, filter bag will be dampened, the dust is not loose, but sticky attached to the filter bag, the fabric hole is blocked, resulting in dust removal, the deduster is too large, can not continue to run, and some paste bag can not dust.
WESP has the advantages of high dust removal efficiency, small pressure loss, simple operation, small energy consumption, no moving parts, no two times of dust, low maintenance cost, short production stop period,working at the dew point temperature below, combined with other flue gas treatment equipment and diversified design forms due to the compact structure.
The medical Psa Oxygen Generator system consists of the air compressor, air-water separation device,dryer, air dew point monitoring device, multi-stage filter, air buffer tank, air moisture monitoring device, Oxygen Generator, oxygen buffer tank, flow meter, online oxygen monitoring device, cylinder manifold system, smart electric control cabinet, computer monitoring system, remote network monitoring system and oxygen booster system.
Because the corrosion phenomenon in the flue gas purification occurs under the condition that theflue gas temperature appears below the acid dew point, the Electromagnetic Pulse Valve should ensure that the system flue gas runs above the dew point temperature.
ETR Oxygen Cylinder Filling System is consisted of the air compressor, air-water separation device, refrigerated air dryer,air dew point monitoring device, multi-stage filter, air buffer tank, air moisture monitoring device, Oxygen Generator, oxygen buffer tank, flow meter, online oxygen monitoring device, oxygen booster and cylinder filling station, smart electric control cabinet, computer monitoring system, remote network monitoring system….