Examples of using Voltage drop in English and their translations into Malay
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
If there's no voltage drop, we're in.
Voltage drop, and the contact drop1.98V.
LED lighting not sensitive to voltage drops;
When the voltage drops lower than standard value, it automatically changes to Stationary Battery Pulse Maintainer state.
Many models have a system to control the voltage drop;
Electromagnetic waves cause serious voltage drops, after which the electronics fail.
Stapling capacity will be reduced when battery voltage drop.
Appendix 4 Current-carrying capacity and voltage drop for cables and flexible cords.
K medium frequency inverter dc spot welding machine ismore suitable for the fluctuation of the power grid and voltage drop.
Atlant models have protection against voltage drops and low noise.
The longer the wire, the bigger the diameter of wire is needed toprevent the resistant of the wire causing significant voltage drop.
Or connect to the DC power source and check the voltage drop of each coil, winding direction and wiring method.
Availability of high-quality isobutane compressors,which guarantee effective cooling even with voltage drops in the network.
Even if a small force is applied to the screw, the voltage drop is still much lower than the boundary required by the VDE0611.
The voltage drop, voltage drop small touch point intrusive also is one of the standard to distinguish socket quality.
Together, put the torque change in large scale, voltage drop is the same.
Voltage drop, touch point voltage drop is also one of the standards to distinguish the quality of Terminal Blocks.
Together, put the torque change in large scale, voltage drop is the same.
A low power factor causes voltage drops and energy losses on the system, making it necessary to oversize all the facilities from the generating station to your electrical panel.
Together, the applied torque varies greatly, and the voltage drop is almost constant.
Even with this innovation, the voltage drop due to the resistance of the system conductors was so high that generating plants had to be located within approximately a mile(1- 2 km) of the load.
At the same time,applying the torque change in large scale, voltage drop is almost the same.
For example, if the voltage drop across R8 measures only 0.3 volt, you must decrease R4′s value(the exact value is up to you to figure out) in order to increase Q3′s base voltage and collector current.
The compressor and the control system of refrigerators are adapted to voltage drops in electrical networks.
Even with a small force applied to the screw, the voltage drop is still much lower than the limit required by VDE0611.
In any event, the cable should be well shielded and have sufficient cross section(at least 0.2 mm2)to limit the voltage drop along its length.
But, connections from a power supply's output to its load have resistance andcurrent flowing through them produces a voltage drop that creates a voltage difference between the supply's output and the actual load.
This resistance can be measured by using a small and measured direct current, or dc,passed through the thermistor in order to measure the voltage drop produced.
Challenge question: what do you think willhappen with a real zener diode, where its voltage drop does change slightly with changes in current?
The supply's two(plus and minus) remote sense connections monitor the actual load voltage, a portion if which isthen fed back to the supply with very little voltage drop because the current through the two remote sense connections is very low.