Examples of using Linear interpolation in English and their translations into Russian
{-}
-
Official
-
Colloquial
Linearization: linear interpolation in 50 points only via OM Link.
Several Kriging methods, inverse distance method,level linear interpolation method 5.
Linear interpolation between successive values of Rsce is authorized.
For intermediate speeds linear interpolation of maximum load rating is allowed.
Linear interpolation of these values for steps smaller than 10 nm is permissible.
Elevation values are calculated by linear interpolation between the start and end.
Linear interpolation shall be used to establish values not shown here.
The difference is smoothstep uses a Hermite interpolation instead of a linear interpolation.
Linear interpolation of these values for steps smaller than 10 nm is permissible.
The years in between the estimated years were imputed based on linear interpolation between data points.
Linear interpolation shall be used to determine the 8-mode test speeds and torques if needed.
The individual capacity at -10° C shall be calculated by linear interpolation from the capacities at 0° C and -20° C.
Linearization: linear interpolation in 50 points(only via OM Link) Preset: initial nonzero value that is always read after resetting the device.
The nominal capacity at -10° C shall be calculated by linear interpolation from the capacities at -20° C and 0° C.
Some iterate the linear interpolation(Newton's method) to calculate the time of collision with a much higher precision than the rest of the simulation.
The nominal refrigerating capacity at -10°C shall be calculated by linear interpolation from the capacities at -20°C and 0°C.
When the profile was converted[into digital format], it was split into equal 2,500 m intervals andthe depth values at these fixed points were determined by linear interpolation.
The set points shall be calculated by linear interpolation between the 1 Hz set points of the reference cycle.
Geometries are linear, in the sense that boundaries are implicitly defined by linear interpolation between vertices.
The effective capacities at -10° C shall be calculated by linear interpolation from the effective capacities at 0° C and -20° C.
In all cases, measurements of nominal and individual capacities will be madeat 0° C and -20° C. The capacities at -10° C will be calculated by linear interpolation.
The nominal refrigerating capacity at -10C shall be calculated by linear interpolation of the capacities at -20C and 0C.
Firstly, the median hatching and creching dates are identified from the data reported under Method A9:penguin breeding chronology(Figure A5) using linear interpolation.
The individual capacities at -10°C can be calculated by linear interpolation of the capacities at -20°C and 0°C.
If values are to be determined between adjacent references oradjacent measured values, linear interpolation shall be used.
At the time they did not havethe density results and had to use the values calculated by linear interpolation between the densities of the pure components.
If values are to be determined between adjacent reference oradjacent measured values, linear interpolation must be used.
Where necessary, the refrigerating capacity of each refrigeration evaporator should be calculated by linear interpolation of the refrigerating capacities measured and calculated at -20° C and 0° C.
All data points recorded under paragraph 1.2. must be connected using linear interpolation between points.
Determination of the negative torque required to motor the engine at idle and at nhi and linear interpolation between these two points.