Examples of using Switch button in English and their translations into Russian
{-}
-
Official
-
Colloquial
Cable with mode switch button.
Mode switch button with cable.
Can't seem to find that switch button.
Remote mode switch button or remote control.
Cable with remote mode switch button.
Releasing switch button will stop the Power Drive.
How to Use Mode Switch Button.
Keep switch button depressed until threading is completed.
Cable with input switch button.
Press switch button on the device it is a button with two rectangles.
Cable with mode switch button.
Please do not confuse it with the switch button(see Point 10), which is formed by the two concentric charging contacts at the end of the torch.
Cable with mode switch button.
Press the switch button gently, as sharp movements may cause figures with a minus appearing on the display:"-0.2" or"-0.4.
Cable with remote modes switch button.
Press and hold the switch button before starting the engine.
English and local language switch button;
Long switch button function-Additional function which can be activated by long pressing(5 sec.) of switch button.
English and local language switch button.
Please do not confuse it with the switch button(see Point 10), which consists of the two concentric charging circles at the end of the torch.
To start the tool, simply press the switch button.
Long switch button function-Additional function which can be activated by long pressing(5 sec.) of switch button. .
Just above the scroll wheel there is a resolution switch button.
Press and hold the last PC port switch button(i.e., the second button on the 2-port model and the fourth button on the 4-port model) till you hear two beeps.
Pry the front panel from the front housing and remove the switch button.
When the switch button is pressed beyond the pressure point,(deep enough so that the switch clicks into position) a small clicking sound can be heard when the button locks into position.
Possible to switch between modes by remote mode switch button.
(3) Turn on the power, set the overvoltage setting value,press the high voltage switch button, slowly rotate the pressure regulator knob, and start boosting until the microampere meter reading reaches 1000μA.
Position of left hand on the casing andproper pressing the switch button.
Scroll+ tilt+ button 3 B: Right button C: Left button D: Buttons 4, 5 and 6 E:DPI switch button F: DPI indicator G: Laser H: Battery compartment I: On/ off button J: Connect button 2 K.
