Examples of using Test button in English and their translations into Russian
{-}
-
Official
-
Colloquial
Test button for compressor overheating protection.
Press and hold the test button for 3 seconds.
Test Button& LEDs to control Battery Status.
Select the Start Test button to run the Echo Test. .
To start the simulation of a bridge,press the test button.
Pressing the test button on the flash will wake it up.
Recurring test as per WHG via test button with SU 501.
The Test button allows you to play-back the chosen sound.
Once the computer is off,test that the RCCB works correctly by pressing the test button.
Pressing the test button will trigger the flash.
To make sure that reports arrive in the specified mailbox,click the Test button to send a test message.
Click the Test button to send a test message.
Full-pressing the camera shutter button or pressing the Master flash test button will wake up flashes in idle mode.
Initially, the test button looks as shown on the screenshot.
When configuring notification settings for an unassigned Security Server,you can send a test message by clicking the Test button.
Select the Start Test button to start the test. .
Test button output levels can be configured see C. Fn-07 below.
Press and hold the test button for three seconds see Fig 3.
Performing a Test Flash To test the fl ash before taking a photograph,check that the ready lamp is lit and press the test button.
Press the Test button and fl ashes will test fi re in sequence.
If the portable power bank has gone to the sleep mode and the device being charged byit is not powered, press the portable power bank level test button.
Built-in test button, can switch to test mode and color test mode.
The insulation monitoring function is controlled from a test button. Costly earthing with anearthing spike and earthing cable are no longer necessary.
Press the test button, issued a product in the range of human hearing the voic e within, suggesting that the products normal operation.
If you plan to use this type of Rule condition,use the Test button on the WebAdmin Interface Router page to see how various addresses are routed.
The test button(8) allows the correct operation of the device to be verified by passing a small current through the orange test wire 9.
Enter an IP address and click the Test button. The IP address status appears. The status shows the IP address you have entered.
Press the Test button and fl ashes with Strato receivers will test fi re as part of Group.
In order to do this, you should press the test button once a month, with a beep signal confirming the device's operating status.
Press the gas gun test button(see picture) to see if there is any sound of air intake or ignition.