Examples of using Longitudinal sections in English and their translations into Serbian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
Usually Acc longitudinal sections already bending the bottom.
Fold the cloth in half face inward and prostrochite him on longitudinal sections.
Double-Acc width of 2 cm longitudinal sections of the lower cloth.
Make longitudinal sections of double Acc width of 2 cm and proutyuzhte it.
Prepare the lining and how its on longitudinal sections of the main panel.
Prostrochite them on a typewriter on the patterns andfurther down the longitudinal sections.
If not, run on longitudinal sections of double Acc width of 1.5 cm.
Cleave and prostrochite him at a distance of 5 mm from the edge of longitudinal sections.
Prostrochite them on and longitudinal sections of the top 5 mm from the edge.
Now fold both of the cloth,right sides together and prostrochite them on longitudinal sections.
Make a single Acc longitudinal sections of the lining 2,5 cm wide and proutyuzhte it.
The seam should be at a distance of 2.5 cm from the longitudinal sections of the lining on both sides.
Prostrochite it on longitudinal sections and the bottom at a distance of 1.5 cm from the edge.
Determine the width of the curtain, using the table below,adding 10 cm Acc allowance for longitudinal sections.
Sostrochite all four parts of longitudinal sections at the same cloth and razutyuzhte allowances.
Cleave with both pairs of tails of the two fabrics andlining right sides inward and prostrochite on longitudinal sections and lower bevelled edge.
Make and proutyuzhte Acc single longitudinal sections of 5 cm wide on each half of the curtains.
Prostrochite longitudinal sections with a seam allowance 1,5 cm Spread the seam and proutyuzhte it.
Cloth curtains andlining right sides together and prostrochite on longitudinal sections on a typewriter. Proutyuzhte seams.
Prostrochite longitudinal sections and down, doing the reverse at the top for greater strength sutures.
If you choose fabric with a pattern,the width of the bottom of the bending and longitudinal sections will depend on the width of the rapport the figure.
Fold the top and longitudinal sections outline the width of 1,5 cm Nadsekite allowance at the junction of the bands.
Wrong side will act as a front to finish the edges of the bottom and longitudinal sections, and the top is curved outward in the form of false lambrequin.
Finishing the longitudinal sections and a bottom- Acc and undercut- one of the most important final operations in the manufacture of items for interior textiles.
In addition, it is possible to make not only the longitudinal sections, experiment, make stars, hearts and other shapes.
Double-Acc longitudinal sections of width 2 cm and the lower slice width of 8 cm Proutyuzhte and how at the intersection of the longitudinal bending and lower sections. .
Fold it in half lengthwise wrong side inwards,bend the edges of the longitudinal sections toward the center proutyuzhte and again fold in half lengthwise.
Fold and zautyuzhte longitudinal sections of width 2.5 cm Fold the lining and the basic matter, right sides inward, carefully bend sections and chipped.
Finally you have done all measurements and calculations,not forgetting the allowances on Acc bottom, top and longitudinal sections, and now know exactly how much fabric you need.
Perform and proutyuzhte double Acc longitudinal sections of width to 6 cm so that the corners were at exactly 90 В°.
